Hardware user’s manual digital video motion detector dvmd1-x version 010 revision a july, 2004 radiant, inc. 2395 kenwood drive boulder, co 80303 (303) 543-0440
Radiant, inc. 2 technical specifications vendor radiant inc. Http://www.Dvmd.Com part number: 801-004 operating temperature range: 0-60c. Power requirements the dvmd1x will accept 8 to 36vdc or 24vac. If dc power is shared between devices the ground must be the same for all units. At 12v input the s...
Radiant, inc. 3 operating configurations the dvmd1-x is a standalone product with its own digital signal processor (dsp). It requires only power and video input and produces video output with overlay and a dry contact relay alarm. The user customizes the performance to accommodate site-specific oper...
Radiant, inc. 4 figure 2b illustrates a dvmd1-x (address=ff0) connected to a host computer. The host communicates to the dvmd-x through a cat5 cable connected to the rj45 port. A crossover cable must be used for direct connections from the host to the dvmd1-x. Dvmd "ff0" video monitor video camera 1...
Radiant, inc. 5 dvmd1-x overview the digital video motion detector (dvmd) measures 3.5"x5"x1.25" and is housed in an extruded aluminum case as shown in figure 3. Figure 3 – dvmd-x the unit receives video from the camera through the bnc connector labeled vin and provides buffered video output (after ...
Radiant, inc. 6 alarm relay usage the alarm relay contact information is on the nc, com and no connectors. Nc is normally closed when the power is "off" to the dvmd1-x. No is normally open when power is "off" to the dvmd1-x. Most users will need the no and com terminals. The nc terminal is brought o...
Radiant, inc. 7 connection instructions connecting the dvmd to a camera and computer is a simple process. The connections should be accomplished in the sequence outlined below. • step one: connect the +12 vdc power supply by attaching the positive supply output to v+ and ground to v-. These screw co...
Radiant, inc. 8 figure 5 – dvmd1-x rev b rear panel • step five: the unit address is internally set to ff0 for the dvmd1-x so there is no rotary switch the rs485 chain is internally terminated so there is no term switch on the dvmd-x. All other dvmd1-x termination switches should not be terminated. ...
Radiant, inc. 9 dvmd1-x ptz jumpers figure 6 below shows the dvmd1-x pcb and identifies the ptz jumpers as shipped. Figure 6 – dvmd1-x enable jumper.
