Radiant DVMD1 User Manual - Radiant, Inc.
Radiant, Inc.
12
•
Step Seven:
Power up the camera, the CCTV monitor and the DVMDs. You should get a video
picture with overlay on the monitor. If you do not get a picture on the monitor re-check
Steps 1 – 6 above. If you do get a video image on the monitor, proceed with loading the
User Interface Software as described in the User Interface – Manager Tools Window
paragraph below.
If the power to the DVMD is off, the video from the camera is connected directly to the
CCTV monitor through an internal video bypass relay. In the power off state, no DVMD
functions occur, and no overlay is generated.
•
Step Eight (Optional PTZ Support)
Connect a system output to the Auxiliary Input (Auxin) screw terminals. Force the output
bit high to disable the DVMD1 alarms and put the product into PAN mode. The PAN
overlay will appear. Move the PTZ camera to the desired new position and wait for the
camera to stop moving. Clear the output bit that allows the DVMD to learn the new
scene in 1 second and look for motion.
User Interface – Manager
The 3.5 inch floppy diskette contains the
Manager.exe
program which provides the user interface
to the DVMD. Power up the PC and insert the 3.5 inch floppy diskette into the floppy drive. You
may run
Manager.exe
from the floppy drive or save the file to the hard drive and run the program
there. Locate the
Manager.exe
file on the floppy drive or hard drive and double click on
Manager.exe
.
Please refer to the DVMD Software User’s Manual for further information.