Radiforce MX242W Instructions For Use Manual - Notice For This Monitor
7
Notice for this monitor
English
Notice for this monitor
Intended use
This product is intended to be used in displaying and viewing digital images for review and analysis
by trained medical practitioners. It does not support the display of mammography images for
diagnosis.
Caution: Federal law (USA) restricts this device to sale by or on the order of a physician.
Attention
• This product may not be covered by warranty for uses other than those described in this manual.
• The specifications noted in this manual are only applicable when the following are used:
- Power cords provided with the product
- Signal cables specified by us
• Only use optional products manufactured or specified by us with this product.
Installation Requirements
• Carefully read the “PRECAUTIONS” (page 3) and always follow the instructions.
• When installing the monitor in a rack, ensure that there is adequate space around the sides, back
and top of the monitor.
• Position the monitor so that there is no light to interfere with the screen.
• If you place this product on a lacquer-coated desk, the color may adhere to the bottom of the stand
due to the composition of the rubber.
Maintenance
• It takes about 30 minutes for the performance of electrical parts to stabilize. Please wait 30 minutes
or more after the monitor power has been turned on or the monitor has recovered from the power
saving mode, and then adjust the monitor.
• Monitors should be set to a lower brightness to reduce changes in luminosity caused by long-term
use and maintain a stable display. Periodically perform constancy tests. Calibrate if necessary. For
details, refer to the User Manuals for the RadiCS/RadiCS LE monitor quality control software.
• Otherwise, parts (such as the LCD panel or the fan) may deteriorate in the long-term. Periodically
check that they are operating normally.
• When the screen image is changed after displaying the same image for extended periods of time,
an afterimage may appear. Use the screen saver or power save function to avoid displaying the
same image for extended periods of time.
• If the monitor displays continuously over a long period of time, dark smudges or burn-in may
appear. To maximize the life of the monitor, we recommend the monitor be turned off periodically.
• The backlight of the LCD panel has a fixed lifetime. When the screen becomes dark or begins to
flicker, please contact your local EIZO representative.
• The screen may have defective pixels or a small number of light dots on the screen. This is due to
the characteristics of the panel itself, and is not a malfunction of the product.