Radiient Select-4 User Manual - page 3
5
Safeguards
Safeguards
Safeguards
Safeguards
►
To reduce the risk of electric shock,
do not expose this product to rain or
moisture.
►
If the wall plug does not fit into your
local power socket, hire an electrician
to replace your obsolete outlet.
►
Do not modify the wall plug. Doing so
will void the warranty and safety fea-
tures.
►
This equipment should be installed
near the socket outlet and the device
should be easily accessible in case it
requires disconnection.
Precautions
Precautions
Precautions
Precautions
►
FCC Regulations state that any unau-
thorized changes or modifications to
this equipment not expressly approved
by the manufacturer could void the
user’s authority to operate this equip-
ment.
►
Operate this product using only the
included external power supply. Use
of other power supplies could impair
performance, damage the product, or
cause fires.
►
In the event of an electrostatic dis-
charge, this device may automatically
turn off. If this occurs, press the power
button to turn the device back on.
►
Protect and route power cords so they
will not be stepped on or pinched by
anything placed on or against them.
Be especially careful at plug-ins, or
cord exit points from this product.
►
Avoid excessive humidity, sudden tem-
perature changes or temperature ex-
tremes.
►
Keep this product away from wet loca-
tions such as bathtubs, sinks, laundries,
wet basements and swimming pools.
►
Use only accessories recommended by
Radiient Technologies to avoid fire,
shock or other hazards.
►
Unplug this product before cleaning.
Use a damp cloth for cleaning. Do not
use cleaning fluids or aerosols, which
could enter the unit and cause damage,
fire or electrical shock. These sub-
stances may also mar the finish of the
product.
►
Never open or remove unit panels or
make any adjustments not described in
this manual. Attempting to do so could
expose you to dangerous electrical
shock or other hazards. It may also
cause damage to your Select-4.
►
Do not attempt to service this unit. In-
stead, disconnect it and contact your
Authorized Radiient Reseller or contact
Radiient Technologies directly.
Compliance Certification
Compliance Certification
Compliance Certification
Compliance Certification
This product complies to the following do-
mestic and international regulations and
standards:
Electromagnetic Compatibility EMC Directive
FCC - Part 15, EN 55022, EN 55024
Safety UL 60950-1, CSA 60950-1, EN
60950-1, IEC 60950-1, CB Scheme
SAF ETY INF ORM ATION
SAF ETY INF ORM ATION
SAF ETY INF ORM ATION
SAF ETY INF ORM ATION
2
IN STAL L ATION AN D SETUP
IN STAL L ATION AN D SETUP
IN STAL L ATION AN D SETUP
IN STAL L ATION AN D SETUP
The Select-4 package contains the Select-4 switch unit, a power supply and an in-
frared remote control.
Remove and unwrap the components from the package. The infrared remote con-
tains a clear plastic battery protection tab. This tab must be removed from the re-
This tab must be removed from the re-
This tab must be removed from the re-
This tab must be removed from the re-
mote before use.
mote before use.
mote before use.
mote before use.
Connect the power supply to the Select-4 unit as shown in the picture below.
Plug the power supply into a power outlet.
Connect HDMI cables (not included) from the HDMI or DVI source(s) to the Select-
4 inputs.
Connect an HDMI cable from the Select-4 output to an HDMI or DVI display or to
another HDMI receiving device, such as an AV receiver.