1200093 user’s guide weather radio alarm clock thank you for purchasing your weather radio alarm clock from radioshack . Please read this user’s guide before installing, setting up, and using your new weather radio..
2 package contents • weather radio alarm clock • ac adapter • user’s guide features • receives local noaa weather radio channels • provides audible alerts • dual-powered • auto channel-scan 1 mount your weather radio place your weather radio on a flat surface, such as a desk, shelf, or table or moun...
3 2 power your weather radio use the supplied 6v, 300ma ac adapter for power or an ac/dc adapter (not included) to connect in your vehicle. You can also install four aa batteries (not supplied) in case ac power fails or is temporarily disconnected. Ac power connection 1. Insert the adapter’s barrel ...
4 ) and ( press to adjust the broadcast and alert volume, or to set the channel number, clock time, and alarm time values. Weather/snooze press to start and stop the weather broadcast or to enable the alarm or snooze feature. Signal strength indicator dc 6v connect the supplied ac adapter or a car a...
5 set hold for 2 seconds to enter function setup mode and press to confirm selections. Clock time alarm time alert on/off switch the weather radio responds to national weather service (noaa) alert broadcasts in two ways: on when alert is set to on and an alert broadcast is received, an alert sounds ...
6 • use only fresh batteries of the required size and type. • do not mix old and new batteries, different types of batteries (standard, alkaline, or rechargeable), or rechargeable batteries of different capacities. • if you do not plan to use the weather radio with batteries for a week or more, remo...
7 set channel 1. Hold down set until you hear a beep. Ch 1-7 (current channel number) flashes. 2. Press set to enable channel selection. N oaa appears. 3. Press ) or ( to manually change the channel and turn on broadcast audio. Hold down ) or ( to automatically search for the strongest channel. 4. P...
8 4. Press or hold down ) or ( to set the hour. 5. Press set to confirm. The minute digits flash. 6. Press or hold down ) or ( to set the clock minutes. 7. Press set to confirm. % and the current signal loss reminder setting ( on or off ) appear. 8. Hold down set to return to the normal display. Or,...
9 n notes: • pm appears to indicate pm hours in alarm and clock setting modes and disappears to indicate am hours. • the signal loss reminder beep does not sound while listening to a nws broadcast. • the backlight is always on when operating with ac power. When operating on battery power, the backli...
10 specifications frequency coverage (mhz): channel 1 .............................................................................162.400 channel 2 .............................................................................162.425 channel 3 ...........................................................
11 • reorient or relocate the receiving antenna. • increase the separation between the equipment and receiver. • connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • consult your local radioshack store or an experienced radio/tv technician for h...
12 protect the environment by recyling used electronics. Go to e-cyclingcentral.Com to find an electronic recycling center near you. ©2011. Radioshack corporation. All rights reserved. Radioshack and radioshack.Com are trademarks used by radioshack corporation. Mance of warranty service. Repaired or...
