Radio Shack 15-1186 User Manual

Cat. No. 15-1186

To mount the TV FM Flush Mount Wall Plate:

1. If there is no wall box, cut a 1

3

/

4

 ¥ 4 inch hole in the

wall at the desired location.

2. Across the top of the hole, position a flat bracket

piece against the inner wall surface and an angled

bracket piece against the outer wall surface (with the

recessed part inside the hole).

3. Thread two of the supplied long bolts through the

two outer holes on the bracket pieces. 

4. Repeat Steps 2 and 3 across the bottom of the hole

so the center hole in the bottom bracket is 3

1

/

4

inches below the center hole in the top bracket (to

match the distance between the mounting holes on

the wall plate).

(L) illus of hole on wall w/

dimension lines

size to fit text margins

(R) illus of wall cross-sect

w/brackets and screws;

Custom Manufactured in Taiwan for RadioShack

A Division of Tandy Corporation

Fort Worth, Texas 76102

15-1186.fm  Page 1  Thursday, July 15, 1999  1:47 PM