Radio Shack 15-1950 Owner's Manual
©
2002 RadioShack Corporation.
All Rights Reserved.
RadioShack and RadioShack.com are trademarks
used by RadioShack Corporation.
15-1950
OWNER’S MANUAL — Please read before using this equipment.
Thank you for buying the RadioShack
Wireless IR Remote Extender, which
extends your existing remote control’s
operating range. The extender lets you
control your TV, VCR, stereo, CD player, or
cable converter from a greater distance than
any of your existing remote controls. You
need not worry about line-of-sight
requirements.
Your extender includes a transmitter and a
receiver. The transmitter senses the infrared
signals from your audio/video equipment’s
remote controls and converts them into
wireless transmissions. The receiver senses
these transmissions, converts them back
into identical infrared signals, then relays
them to your audio/video equipment.
Full Remote Control Compatibility
receives, converts, and relays infrared
signals from virtually any infrared remote
control.
Powerful Radio Frequency
lets you
control audio/video equipment from
anywhere in your house, up to 100 feet (30.5
meters) away.
+056#..#6+10
+
056#..+0)
"
6*'
"4
'%'+8'4
"
1. Place the receiver in front of the audio/
video equipment and position it:
• within 20 feet (6.1 meters) of the
audio/video equipment’s remote
sensor
• where the front of the receiver
directly faces the audio/video
equipment’s remote sensor
The first time you use the extender,
rotate and adjust the receiver’s
telescoping antenna until you get the
best reception.
2. Fully extend the telescoping antenna.
You can easily identify the receiver or
transmitter from the label pasted on the
bottom of the product. The receiver is
equipped with
DC 12V
and
IR OUT
jacks,
and the transmitter is equipped with one
DC 12V
jack.
3. Connect the supplied AC adapter’s
barrel plug into the receiver’s
DC 12V
jack, then connect the adapter’s AC
plug to a standard AC outlet.
.
.
.
.
#
"+/2146#06"
#
If an icon appears at the end of a paragraph,
go to the box on that page with the
corresponding icon for pertinent information.
Rý
— Warning
#
— Important
.
.
.
.
— Caution
°
°
°
°
— Hint
±
— Note
.
"%#76+10"
.
You must use a Class 2 power
source that supplies 12V DC and
delivers at least 120 mA. Its cen-
ter tip must be set to positive and its plug
must fit the receiver's DC 12V jack. The
supplied adapter meets these specifi-
cations. Using an adapter that does not
meet these specifications could damage the
receiver or the adapter.
•
Always connect the AC adapter to the
receiver before you connect it to AC power.
When you finish, disconnect the adapter
from AC power before you disconnect it
from the receiver.
!
9KTGNGUU"+4"4GOQVG"'ZVGPFGT
The lightning symbol is intended to
alert you to the presence of uninsulated
dangerous voltage within this
product’s enclosure that might be of
sufficient magnitude to constitute a risk of electric
shock. Do not open the product’s case.
The exclamation symbol is
intended to inform you that
important operating and
maintenance instructions are
included in the literature accompanying
this product.
!
WARNING:
To reduce the risk of fire or shock hazard, do not expose this
product to rain or moisture.
..
CAUTION
..
CAUTION:
TO REDUCE THE
RISK OF ELECTRIC SHOCK, DO
NOT REMOVE COVER OR BACK.
NO USER-SERVICEABLE PARTS
INSIDE. REFER SERVICING TO
QUALIFIED PERSONNEL.
RISK OF ELECTRIC
SHOCK DO NOT OPEN
!
(%%"&'%.#4#6+10"
1("%10(14/+6;
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions: (1) this device
may not cause harmful interference, and
(2) this device must accept any
interference received, including
interference that may cause undesired
operation.
Product:
Wireless IR Remote
Extender
Model:
15-1950
Responsible
Party:
RadioShack
100 Throckmorton
Fort Worth, TX 76102
Phone:
817-415-3200
15-1950.fm Page 1 Thursday, May 23, 2002 10:07 AM