Radio Shack 1500458 User Manual - page 4
4
Set Up the IR Repeater System
1.
Use the two supplied mounting screws to mount the
IR repeater box on the wall.
2.
Connect the AC adapter to the repeater box’s
POWER port and then to an AC outlet.
3.
Plug the receiver into the repeater box’s RX jack.
4.
Plug the transmitter into the repeater box’s TX jack.
• The transmitter lets you control up to six devices.
• Position the emitter facing your device’s IR sensor
within 1.6 feet (line of sight). You can remove the
adhesive backing to affi x each emitter to a fl at surface.
5.
Point your remote control (not supplied) at the
receiver within 23 feet (direct line of sight) to control
your A/V device(s).
6.
To extend the length of the transmitter cable, plug
the extension cable into the repeater box’s TX jack.
7.
Plug the transmitter into the connector of the
extension cable, then position the emitter(s).
n
Note:
• Use the supplied AC adapter only. Using an AC adapter
not designed for this product may cause damage.
• Disconnect the AC adapter from the AC outlet before
unplugging it from the IR repeater box.