3200029 user’s guide 4-channel stereo microphone mixer thank you for purchasing your microphone mixer from radioshack . Please read this user’s guide before installing, setting up, and using your new mixer..
2 mono/stereo power switch battery low indicator mic jacks channel 1-4 dc 9v aux 2 l/r, aux 1 l/r connect to audio devices output l/r connect to speaker system or recording device.
3 package contents • mixer • user’s guide features • connect up to two separate stereo or four separate mono sources to mix your sounds at the right levels. • four slide-action channel faders allow maximum control over sound mixing. Power your mixer install the battery insert one 9v battery (not sup...
4 use ac power (optional) connect a 9v ac adapter (not supplied) to the dc 9v jack according to the marked polarity. Connect the other end to the power source. N note: • always connect the ac adapter to the mixer before you connect it to ac power. When you finish, disconnect the adapter from ac powe...
5 connect the mixer use shielded audio cables (not supplied) for all input connections. Signals from connected input sources are routed to the corresponding channels on the mixer. Two stereo inputs connect the line level outputs from one device to the mixer’s aux 1 input r and l jacks. Connect the l...
6 output to play the mixer’s output through your speaker system, use an audio phono cable (not supplied) to connect the mixer’s output l and r jacks to your receiver or amplifier’s line input jacks. Recording to record the mixer’s output, use an audio phono cable (not supplied) to connect the mixer’...
7 mixing mono or stereo to mix mono signals with stereo signals, set stereo/ mono to stereo . When stereo/mono is set to mono : • the mixer routes monaural input signals of devices connected (separately) to the mixer’s aux 1 l , aux 1 r , aux 2 l , aux 2 r jacks to both outputs. • the mixer changes ...
8 specifications input sensitivity: mic .......................................................................................1.5 mv/600 ohm line .....................................................................................150 mv/27k ohm output level at 10k ohm load ...........................
9 (e) transportation, shipping or insurance costs; (f) costs of product removal, installation, set-up service, adjustment or reinstallation; and (g) claims by persons other than the original purchaser. Should a problem occur that is covered by this warranty, take the product and the radioshack sales...
10 some states do not allow limitations on how long an implied warranty lasts or the exclusion or limitation of incidental or consequential damages, so the above limitations or exclusions may not apply to you. This warranty gives you specific legal rights, and you may also have other rights which va...
