Radio Shack 40-4093 Owner's Manual
©
2002 RadioShack Corporation.
All Rights Reserved.
RadioShack and RadioShack.com are trademarks
used by RadioShack Corporation.
40-4093
OWNER’S MANUAL — Please read before using this equipment.
Your RadioShack 2-Way In-Wall Speaker
features a crossover, a 5
1
/
4
-inch woofer for
rich lows, and a 1-inch tweeter for crisp
highs. The speaker can handle up to 80 watts
of music power. The wing-type mounting
system makes it easy to mount your speaker
flush with the ceiling or wall, making it ideal
for unobtrusive use in a surround-sound
system. The frame and grille can also be
painted to match the room’s decor.
+056#..#6+10
24'2#4+0)
"
6*'
"
.1%#6+10
To mount your speaker, you need the
following items (not supplied, available at
your local RadioShack or online at
RadioShack.com).
• drywall or keyhole saw
• wire stripper
• Phillips screwdriver
• pencil or marker
• 18–20 gauge speaker wire
1. Be sure the mounting surface is between
3
/
8
inch and 1
1
/
4-
inch thick, with at least a
2
3
/
4
-inch clearance behind the mounting
surface and no wall studs or other
objects to block the back of the speaker.
2. Remove the inner cardboard disc from
the supplied template/paint mask and
keep it for later. Use the outer portion as
a template to mark the cutout hole size
and location for mounting the speaker.
3. Use a drywall or keyhole saw to cut the
hole.
.
24'2#4+0)
"
6*'
"
52'#-'4
If you choose to paint the frame and grille,
paint them and let them dry before you
connect the speaker wire or mount the
speaker.
To remove the grille for painting, insert a
paper clip into one of the grille openings, then
pull up. Or, you can carefully twist the plastic
frame back and forth until the grille edge
becomes exposed, then lift the grille to
remove it.
Carefully remove the dust cloth from behind
the grill and replace it after you are finished
painting.
±
You can also paint the frame to match your
wall or ceiling. To prevent paint from entering
the speaker, remove the grille and insert the
supplied cardboard paint mask. After the
paint is dry, remove the paint mask and
replace the grille.
%100'%6+0)
"
6*'
"
52'#-'4
"
9+4'5
Your local RadioShack store sells a wide
selection of speaker wire. We recommend
you use wire that is color-coded or marked on
one side to help you connect the wire
correctly.
1. Route the speaker wire to the speaker
from the receiver.
±
2. Separate about 4 inches of speaker wire
at each end.
#
"
+/2146#06
"
#
If an icon appears at the end of a paragraph, go
to the box on that page with the corresponding
icon for pertinent information.
Rý
— Warning
#
— Important
.
— Caution
°
°
°
°
— Hint
±
— Note
.
"
%#76+10
"
.
Be sure not to cut into any existing wiring or
plumbing hidden behind the wall.
±
"
016'
"
±
"
Do not paint the speaker element. We
recommend you spray-paint the grille so paint
does not block the holes.
Paint Mask
±
"
016'5
"
±
"
•
Avoid routing the speaker wire near electrical
wires.
•
Do not nail or staple the speaker wire.
4 inches
1
/
4
inch
4/
9C[
"
+P
/
9CNN
"
5RGCMGT