1. DL manuals
  2. Radio Shack
  3. Cordless Telephone
  4. 43-3533
  5. Owner's Manual

Radio Shack 43-3533 Owner's Manual

Manual is about: RadioShack 900 MHz Cordless Telephone with Headset Jack Owner's Manual

Summary of 43-3533

  • Page 1

    43-3533/3534/3541/3542/3543 © 2002 radioshack corporation. All rights reserved. Radioshack and radioshack.Com are trademarks used by radioshack corporation. E nergy s tar and the e nergy s tar certification mark are registered us marks. Owner’s manual please read before using this equipment. # "+/21...

  • Page 2

    2 +/2146#06"5#('6;" +05647%6+105 when using your telephone equipment, basic safety precautions should always be followed to reduce the risk of fire, electric shock and injury to persons, including the following: 1. Read and understand all instructions. 2. Follow all warnings and instructions marked ...

  • Page 3

    Im p o rta n t s a fe ty in s tr u c tio n s 3 15. Never push objects of any kind into this product through cabinet slots as they may touch dangerous voltage points or short out parts that could result in a risk of fire or electric shock. Never spill liquid of any kind on the product. 16. To reduce ...

  • Page 4

    4 in tr oduc tion 4. Exercise care in handling the battery pack in order not to short it with conducting materials such as rings, bracelets, and keys. The battery or conductor may overheat and cause burns. 5. Charge the battery pack provided or identified for use with this product only in accordance...

  • Page 5

    In s ta lla ti o n 5 to mount the phone directly on a wall, you need two screws (not supplied) with heads that fit into the keyhole slots on the back of the base. Drill two holes 3 15 / 16 inches (100 mm) apart. Then thread a screw into each hole, letting the heads extend about 1 / 8 inch (3 mm) fro...

  • Page 6

    In s ta lla ti o n 6 4 '%*#4)+0) " 6*' "$ #66'4; "2 #%- • if the charge/in use indicator does not light when you place the handset on the base, be sure the battery pack and ac adapter are correctly and securely con- nected. Also, check the charging contacts on the hand- set and the base. If the cont...

  • Page 7

    O perat ion 7 1. Lift the handset and listen for a dial tone. 2. Press any number other than 0 . ± if the dial tone stops, you have touch-tone service. If the dial tone continues, you have pulse service. To set the dialing mode, hold down flash until the phone beeps and talk/batt flashes, then press...

  • Page 8

    O perat ion 8 7 5+0) "6 10' "5 '48+%'5 " 10 " # "2 7.5' ". +0' some special services require tone signals (such as bank- by-phone). If you have pulse dialing, you can still use these special tone services. 1. Dial the service’s main number. When the service answers, press tone/ ∗ . Any additional nu...

  • Page 9

    O perat ion 9 3. Enter the number and any tone and pause entries (see “using tone services on a pulse line” on page 8 and “entering a pause” on page 9). ± 4. Press mem again, then enter the memory location number ( 0 – 9 ) where you want to store the number. A tone sounds to indicate that the number...

  • Page 10

    T roubleshoot ing 10 6417$.'5*116+0) 2tqdngo" 5wiiguvkqpu low volume or unusual sounds. Someone has picked up another phone on the same line. Hang up the other phone. If you are using the headset, make sure the headset’s plug is properly connected to the jack. Severe noise inter- ference. Keep the h...

  • Page 11

    Care 11 if you still have problems, disconnect the phone. If other phones on the same line work properly, the fault is in this phone or its installation. If you cannot find the problem, take the phone to your local radioshack store for assistance. %#4' keep the phone dry; if it gets wet, wipe it dry...

  • Page 12

    43-3533/3534/3541/3542/3543 uczz01367zz 06a02 printed in china radioshack corporation fort worth, texas 76102 notice is not practical, the phone company notifies you as soon as possible and advises you of your right to file a complaint with the fcc. Also, the phone company can make changes to its li...