Radio Shack 43-3808A Owner's Manual

Manual is about: Digital Answering System

Summary of 43-3808A

  • Page 1

    © 2002 radioshack corporation. All rights reserved. Radioshack and radioshack.Com are trademarks used by radioshack corporation. 43-3808a owner’s manual — please read before using this equipment. 4'#& " 6*+5 " $'(14' " +056#..#6+10 your digital answering system is etl listed to ul standards and meet...

  • Page 2

    2 we have designed your answering system to conform to federal regulations, and you can connect it to most telephone lines. However, each answering system (and each device, such as a telephone or answering machine) that you connect to the telephone line draws power from the telephone line. We refer ...

  • Page 3

    The f cc wants you to know 3 affect the operation of this telephone. The telephone company notifies you of these changes in advance, so you can take the necessary steps to prevent interruption of your telephone service. 6*' " (%% " 9#065 " ;17 " 61 " -019 this equipment has been tested and found to ...

  • Page 4

    4 features • reorient or relocate the receiving antenna. • increase the separation between the equipment and receiver. • connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • consult your local radioshack store or an experienced radio/tv technici...

  • Page 5

    Features 5 system is fully digital, there are no tape mechanisms to wear out and no tapes to bother with. Day/time stamp — records the day and time each message was recorded. Call screening — lets you listen to incoming calls so you can decide whether or not to answer a call. Remote operation — lets...

  • Page 6

    Prepa ration 6 24'2#4#6+10 + 056#..+0) " 6*' " $ #%-72 " $ #66'4; if ac power fails or you unplug the system, one 9v alkaline battery (not supplied) is needed to save any re- corded messages and the settings for the day and time. For the best performance and longest life, we recommend you use a radi...

  • Page 7

    Pre paration 7 standard ac outlet. The display lights and 9h 9h 9h 9h appears. The system initializes in about 20 seconds, then sounds 4 tones. && && && && and ## ## ## ## alternately appear. If you did not install a backup battery, be be be be , && && && && , and ## ## ## ## alternately appear. % 1...

  • Page 8

    Prepa ration 8 6 740+0) " 6*' " 5 ;56'/ " 1 0 1 1 (( to turn on the system, press on/off/ stop . The display lights and the system sounds a tone. The system is set to answer calls. To turn it off, press on/off/stop . The display turns off and the system sounds 2 tones. # &,756+0) " 6*' " 8 1.7/' pus...

  • Page 9

    Pre paration 9 3. While holding down skip/time set/check, press memo/2 way/ hour . The system announces “1 am”. &' &' &' &' appears on the display. Repeatedly press memo/2 way/ hour until you hear or see the correct hour. 4. While holding down skip/time set/check, press play/pause/ min . The system ...

  • Page 10

    Prepa ration 10 messages, the system answers after two rings. Otherwise, the system answers after four rings. This lets you avoid unnecessary charges when calling by long distance to check your messages. If you hear more than two rings, you know you can hang up because the system has no new messages...

  • Page 11

    Operation 11 1. Hold down repeat/annc/day . 7' 7' 7' 7' flashes on the display, and the system sounds a tone. 2. Speak your message clearly into the microphone from about 10 inches away from the system. 3. Release repeat/annc/day when you finish your message. The system sounds a tone and automatical...

  • Page 12

    12 operation than 7 seconds, or the maximum message length is reached, the system hangs up and resets to answer the next call. The number flashes to indicate a new incoming message has been recorded. When the system is answering a call or recording a message, if any phone on the same line is picked ...

  • Page 13

    Operation 13 messages (see “deleting messages” on page 17). If memory is full, the system announces “memory is full” when you record an outgoing message or memo. 7 5+0) " # 00170%' / 1 0.; " your system’s announce-only feature lets you set the system to play a message for the caller, then automatica...

  • Page 14

    14 operation when the system is set for announce- only, you cannot set it to record incoming messages using the remote commands. To turn off the announce-only feature so callers can leave messages, slide incoming msg to either 1 or 5 min . 5 %4''0+0) " % #..5 to screen calls, let the system answer, ...

  • Page 15

    Operation 15 3. When you finish speaking, release memo/2 way/hour . The system sounds a tone. The number flashes on the display until you play the memo. 4 '%14&+0) " # " 6 91 / 9 #; " 2 *10' " % 108'45#6+10 you can record both sides of a conversation on any phone connected to the same phone line as ...

  • Page 16

    16 operation to listen to messages , press play/ pause/min . The system plays each new message and the sequence number appears. The system announces the day and time the message was recorded. After you play all the new messages, the display shows the total number of recorded messages, and the system...

  • Page 17

    Remo te ope ration 17 & '.'6+0) " / '55#)'5 you can delete messages individually during playback, or all at once after playback. To delete a particular incoming message, memo, or two-way phone conversation (after listening to it), press delete during playback. To delete all messages after playback, ...

  • Page 18

    18 remo te op eration bottom of the system. Enter the security code after the system answers and sounds two tones. Within 7 seconds, enter one of the remote commands. 1 2'4#6+0) " 6*' " 5;56'/ " (41/ " # " 4 '/16' " . 1%#6+10 dial your phone number. Even if the system is off, it will turn on and ans...

  • Page 19

    Ca re 19 %#4' if the system gets wet, wipe it dry immediately. Use and store the system only in normal temperature environments. Do not drop it. Keep the system away from dust and dirt, and wipe it with a damp cloth occasionally to keep it looking new. 5'48+%' " #0& " 4'2#+4 if your system is not pe...

  • Page 20

    Radioshack corporation fort worth, texas 76102 43-3808 lib850y1 01a02 printed in china a limited one-year warranty this product is warranted by radioshack against manufacturing de- fects in material and workmanship under normal use for one (1) year from the date of purchase from radioshack company-o...