1. DL manuals
  2. Radio Shack
  3. Telephone
  4. 43-652
  5. Owner's Manual

Radio Shack 43-652 Owner's Manual - Features

Manual is about: Radio Shack OWNER'S MANUAL Two-Line Speakerphone ET-652

Summary of 43-652

  • Page 1

    Cat. No. 43-652 owner’s manual please read before using this equipment. Et-652 two-line speakerphone 43-652.Fm page 1 friday, august 13, 1999 11:00 am.

  • Page 2: Features

    2 features your radioshack et-652 two-line speakerphone lets you make or receive calls on two separate telephone lines using either the handset or the built in speakerphone. You can connect up to five et-652s to the same telephone line (depending on the phone line’s power; see “read this before inst...

  • Page 3

    3 read this before installation your et-652 conforms to federal regula- tions, and you can connect it to most telephone lines. However, each device that you connect to the telephone line draws power from the line. We refer to this power draw as the device’s ringer equivalence number, or ren. The ren...

  • Page 4: Contents

    4 contents installation ............................................................................................................... 5 mounting the phone ........................................................................................... 5 connecting the ac adapter ..........................

  • Page 5: Installation

    5 installation mounting the phone you can place the et-652 on a desk or table, mount it on a standard wall plate, or mount it directly on a wall. Choose a location that is: • near an ac outlet • near a modular telephone line jack • out of the way of normal activities caution: you must use a class 2 ...

  • Page 6

    6 • the usoc number of the two-line jack to be installed is rj14c (rj14w for a wall plate). The usoc number of a single-line jack is rj11c. Plug one end of the supplied two-line telephone cord into the jack on the back of the phone. Then plug the cord’s other end into a modular telephone line jack. ...

  • Page 7

    7 mounting on a wall or wall plate notes: • when mounting the et-652 on a wall plate, use the supplied short modular cord to connect the phone to the wall plate jack. Your local radioshack store carries a variety of phone line cords. • to mount the et-652 directly on a wall, you need two screws (not...

  • Page 8

    8 setting the dialing mode set mode on the side of the phone for the type of service you have. If you are not sure which type you have, do this test. 1. Set mode to tone . 2. Press line 1 . 3. Lift the handset and listen for a dial tone. 4. Press any number other than 0 . Note: if your phone system ...

  • Page 9

    9 confirming the line numbers follow these steps to determine which phone number is connected to which line. 1. Press line 1 , then lift the handset. 2. Dial one of your phone numbers. If the line 2 indicator flashes, the number is connected to line 2. If you hear a busy signal, the number is connec...

  • Page 10

    10 4. Remove the adjustment tool from its bracket on the bottom of the phone. 5. Use the adjustment tool to turn the corresponding line 1 adjust con- trol on the back of the phone until the indicator flashes slowly. 6. Press line 1 . If the indicator still flashes slowly, turn adjust until it lights...

  • Page 11: Operation

    11 operation making and answering calls to place a call, press the line button for an available line. Then, lift the handset, or press speaker to use the speaker- phone, and dial as you would with any other phone. When you receive a call, that line’s indi- cator flashes. To answer the call, press th...

  • Page 12

    12 using hold to place a call on hold, press hold . The line’s indicator flashes slowly. Note: pressing another line button with- out pressing hold disconnects the cur- rent call. To release a call from hold, press that line’s button, then press speaker (if us- ing the speakerphone) or pick up the h...

  • Page 13

    13 using tone services on a pulse line some special services, such as bank-by- phone, require tone signals. If you have pulse dialing, you can still use these spe- cial tone services by following these steps. 1. Be sure mode is set to pulse . 2. Call the service’s main number. 3. When the service an...

  • Page 14

    14 7. When you finish storing numbers in memory, set norm/store to norm . For each stored number, write the name of the person or company on the memo- ry index. Use a paper clip to lift off the in- dex’s plastic cover. Replace the cover. To replace a stored number, just store a new one in its place....

  • Page 15: Troubleshooting

    15 troubleshooting we do not expect you to have any problems with your et-652, but if you do, these suggestions might help. If you still have problems, disconnect the et-652. If other phones on the same line work properly, the fault is in this phone or its installation. If you cannot find the prob- ...

  • Page 16: Care And Maintenance

    16 care and maintenance your radioshack et-652 two-line speakerphone is an example of superior design and craftsmanship. The following suggestions will help you care for your cordless telephone so you can enjoy it for years. Keep the et-652 dry. If it gets wet, wipe it dry immediately. Liquids might...

  • Page 17

    17 the fcc wants you to know in the unlikely event that your telephone causes problems on the telephone line, the telephone company can disconnect your service. The telephone company normally attempts to notify you in ad- vance. If advance notice is not practical, the telephone company notifies you ...

  • Page 18: Notes

    18 notes 43-652.Fm page 18 friday, august 13, 1999 11:00 am.

  • Page 19

    19 43-652.Fm page 19 friday, august 13, 1999 11:00 am.

  • Page 20

    Radioshack a division of tandy corporation fort worth, texas 76102 811081580a 09a98 printed in china limited one-year warranty this product is warranted by radioshack against manufacturing defects in material and workman- ship under normal use for one (1) year from the date of purchase from radiosha...