Radio Shack 49-2513 Owner's Manual - Making The Connections
9
MAKING THE CONNECTIONS
Cat. No. 49-2511 9-Inch Security Monitor
Cautions:
• Do not attempt to open the cam-
era’s case, as this will destroy its
weather resistant quality and will
void the system's warranty.
• Always disconnect all components
from the AC power during installa-
tion.
Follow these steps to connect the sys-
tem’s components.
1. Connect the camera cable's mini-
DIN plug to
CAMERA INPUT
on the
back of the distribution box.
Caution: If your camera is located
less than 65-feet from the distribu-
tion box, coil the cable carefully to
take up the slack and secure it in
place. Do not cut or splice the
cable nor leave it unsecured.
2. Connect the supplied AC
adapter's barrel plug to
12VOLT
DC
on the distribution box.
Caution: You must use a
Class 2 power source
that supplies 12 volts DC
and delivers at least 400 mA. Its
center tip must be set to positive
and its plug must fit the distribu-
tion box's
12VOLT DC
jack. The
supplied adapter meets these
specifications. Using an adapter
that does not meet these specifi-
cations could damage the cam-
era, your monitor, or the adapter.
Lens
PIR Sensor
Supplied AC Adapter
Cable Supplied with
Cat. No. 49-2511
Distribution
Box
TALK
Button
Microphone
Remote Motion Alarm
To VCR Controller (RSU 12135851)
Audio IN-Red
Video OUT-Yellow
Audio OUT-White
MIC
Talk Indicator
External Alarm
Connections
(not shown)
Camera
VCR Jacks
Camera Jacks
!
Connect
49-2513.fm Page 9 Wednesday, January 19, 2000 4:41 PM