Radio Shack 49-840 Installation Manual - Introduction

Manual is about: Auto Security Alarm System

Summary of 49-840

  • Page 1

    Cat. No. 49-840 installation manual rs-4000 auto security alarm system read this entire manual before you begin installation. 49-840in.Fm page 1 thursday, august 19, 1999 10:47 am.

  • Page 2: Introduction

    2 need help? Call 1-800-598-2527 introduction this installation manual guides you through the steps you will take to in- stall your alarm system. It includes a checklist that keeps you on track and a master wiring diagram that provides an overview of the installation. Plus, this manual has specific,...

  • Page 3: Checklist

    3 need help? Call 1-800-598-2527 checklist follow this checklist in order and properly identify all connection points before you make any connection. Keep this page folded open as you proceed through the manual. 4 here after you complete this section: on page estimated time o “determining your vehic...

  • Page 4: Contents

    4 need help? Call 1-800-598-2527 contents before you begin the installation ................................................................. 5 using wire piercing probe adapters ......................................................... 6 installation ...................................................

  • Page 5

    Need help? Call 1-800-598-2527 5 before you begin the installation in addition to this installation manual, our car alarm includes the following items. Locate each as you unpack the system. Main module siren two remote contols main wiring harness starter disable relay status indicator with bracket a...

  • Page 6

    6 need help? Call 1-800-598-2527 before you install the system, thor- oughly read the “installation” section of this manual. Then decide where to mount the control module and its components and where to route all wiring. Be sure each component’s wires reach from the main control module’s mounting lo...

  • Page 7: Installation

    Need help? Call 1-800-598-2527 7 installation determining your vehicle’s power door lock type there are three basic types of power door locks: type a: requires a positive pulse on the lock/unlock control wires to lock or unlock the door. Type b: requires a ground pulse on the lock/unlock control wir...

  • Page 8

    8 need help? Call 1-800-598-2527 type b switch test use the meter or test light to find a point on the fuse block that pro- vides a constant source of +12 volts. Touch one lead to that point on the fuse block, and the other lead to one of the control wires. Operate your power door locks. If the ligh...

  • Page 9

    Need help? Call 1-800-598-2527 9 2. Touch your meter or test light’s positive lead to a point on the fuse block that has constant 12 volts. Use the other lead to probe the control wire. Then open the door. If the test light turns on or the meter indicates 12 volts, your vehicle has negative-switched...

  • Page 10

    10 need help? Call 1-800-598-2527 5. Turn off the engine. Then cut the wire at a point where there are at least several inches of wire on each side of the cut. Be sure both wire ends are away from all other metal objects under the dash. Important note: if you cut the correct wire, you will be unable...

  • Page 11

    Need help? Call 1-800-598-2527 11 finding constant and ignition power your system operates from 12 volts and draws up to 15 amps of current. In addition to constant 12 volts, the system needs a source of power that is on only when the ignition is on (usually referred to as ignition power). Follow th...

  • Page 12

    12 need help? Call 1-800-598-2527 3. Use pliers to squeeze down the tapping blade. 4. Close the insulated cover so it snaps. Mounting the main module select a location for the main module where it is completely concealed and difficult to access after installation. An ideal location is usually under ...

  • Page 13

    Need help? Call 1-800-598-2527 13 mounting and connecting the siren select a location under the vehicle’s hood for the siren. For the best re- sults, the location should meet the fol- lowing conditions. • the mounting location should be solid and have no mechanisms or moving parts on its other side....

  • Page 14

    14 need help? Call 1-800-598-2527 mounting and connecting the anti- carjacking switch select a location for the anti-carjack- ing switch. You should be able to reach the switch when sitting in the driver’s seat, but the switch should be hard to find. A typical mounting loca- tion is under the dash. ...

  • Page 15

    Need help? Call 1-800-598-2527 15 3. Connect the module’s orange wire to the bullet connector on the harness’s orange wire. 4. Use a wire tie to secure the mod- ule to a nonmoving part under the dash. Connecting to power door locks if you have type c door locks, call 1- 800-598-2527 for additional i...

  • Page 16

    16 need help? Call 1-800-598-2527 if the sensor has both warning and alert triggers, use red wire tap-ins to connect the warning trigger to the harness’s green wire and the alert trigger to the harness’s yellow wire. Connecting accessory devices follow the instructions that come with the accessory t...

  • Page 17: Specifications

    Need help? Call 1-800-598-2527 17 specifications sound pressure level (w/13.8v dc power) . . . . . . . . . . . . . 120 db at 1 meter current draw (system only, not including parking lights or optional accessories) standby . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ...

  • Page 18: Master Wiring Diagram

    18 need help? Call 1-800-598-2527 master wiring diagram 49-840in.Fm page 18 thursday, august 19, 1999 10:47 am.

  • Page 19

    Need help? Call 1-800-598-2527 19 2-wire status indicator harness red constant +12 volts in brown parking lights out (+) black ground in grey siren out (+) yellow major trigger in (–) white/yellow button 2 accessory out (–) green minor trigger in (–) white/red button 3 accessory out (–) black/blue p...

  • Page 20

    Radioshack a division of tandy corporation fort worth, texas 76102 7/97 printed in the usa 49-840in.Fm page 20 thursday, august 19, 1999 10:47 am.