Radio Shack 63-5048 Owner's Manual
©
2003 RadioShack Corporation.
All Rights Reserved.
RadioShack and RadioShack.com are trademarks used by
RadioShack Corporation.
OWNER’S MANUAL —
Please read before using this equipment.
www.radioshack.com
SM
Thank you for your purchasing the
RadioShack Thermometer Watch. It
functions as a watch with dual timekeeping,
alarm, timer, stopwatch, and thermometer.
OPERATION
Remove the protective film from the display
before use. To view the display in the dark,
press
SPLIT/RESET
. The backlight turns on
for about three seconds.
S
ETTING
THE
T
IME
AND
T
EMPERATURE
1. Repeatedly press
MODE
until the time,
day, and date appear.
Ô
2. Press
ADJUST
. The
second digits flash.
Ô
3. Press
ST./STP.
to reset the seconds to
zero.
4. Repeatedly press
MODE
to set the hour,
minutes, year, month, date, and
temperature (Celsius versus
Fahrenheit), then repeatedly press and
hold down
ST.STP.
to set the digits as
desired.
Ô
5. Press
ADJUST
when you are finished
setting the time.
S
ETTING
THE
A
LARM
You can set the alarm to sound daily at a
preset time, or on a specified date at a
preset time. If you do not press a button
within two minutes, the watch returns to
alarm mode.
1. Repeatedly press
MODE
until
AL
appears.
2. Repeatedly press
SPLIT/RESET
to turn on
or off the alarm or
hourly chime.
i
appears for the alarm,
!
appears for the hourly chime. When
the hourly chime is on, the watch beeps
twice every hour on the hour.
3. Press
ADJUST
. The alarm hour flashes.
4. Repeatedly press or hold down
ST./STP.
to set the alarm hour.
5. Press
MODE
to confirm
.
6. Repeatedly press or hold down
ST./STP.
to set the alarm minutes.
7. Repeat steps 5 and 6 to preset a date
for the alarm if desired.
8. Press
ADJUST
when you are finished
setting the alarm. The alarm sounds
about 20 seconds at the set time.
Ô
S
ETTING
THE
D
UAL
T
IME
This features allows you to view time for a
city in another time zone. The time shown on
the upper half of the display is the current
local time; the time on the lower half of the
display is the dual time. If you do not press a
button within two minutes, the watch returns
to dual time mode.
1. Press
MODE
until
DT
appears.
2. Press
ADJUST
. The
hour digits flash.
3. Repeatedly press or hold down
ST./STP.
to set the hour.
Ô
4. Press
MODE
to confirm.
5. Repeat steps 3 and 4 to set the
minutes.
6. Press
ADJUST
when you are finished
setting the dual time.
U
SING
THE
T
IMER
AND
S
TOPWATCH
In Timer Mode
The timer function enables you to set a time
to count down from (up to 23 hours, 59
minutes, 59 seconds). If you do not press a
button within two minutes, the watch returns
to timer mode.
1. Repeatedly press
MODE
until
T’R
appears.
2. Press
ADJUST.
The
hour digits flash.
3. Repeatedly press
ST./STP.
to change
the selected digits to your desired
setting.
4. Repeatedly press
MODE
to select the
minutes and seconds.
Ô
5. Press
ADJUST
to exit.
6. Press
ST./STP.
to start your timer. To
stop the timer, press
ST./STP.
again.
Ô
NOTE
Ô
Setting the Time and Temperature
• Press ST./STP. to toggle between day and
temperature.
• When you enter setting mode, the weekday
or temperature display changes to year.
• Repeatedly press SPLIT/RESET while in
time setting mode to select 12- or 24-hour
time format.
PM
appears for a PM hour in
12-hour time,
24H
appears for 24-hour time.
• You can set the year from 1985 to 2029.
• For the most accurate temperature readings,
keep your watch away from warm surfaces.
• If you do not press a button within about two
minutes while in time/temperature setting
mode, the clock returns to time mode.
Setting the Alarm
The alarm sounds for about 20 seconds at the
set time. Press any button to silence the alarm.
Setting the Dual Time
Repeatedly press SPLIT/RESET to select 12-
or 24-hour time format.
Using the Timer and Stopwatch
• In setting mode, press SPLIT/RESET to
toggle between normal counting and
repeated counting. Normal counting begins
from the time you set, and counts down to
zero. Repeated counting begins from the
time you set, counts down to zero, then
repeats the countdown sequence.
AUTO
appears on the display when in repeated
counting mode.
• If
00:00’00
appears on the display, the clock
will count down from 23:59’59 automatically
after you press ST.STP.
Thermometer Watch
!
IMPORTANT
!
If an icon appears at the end of a paragraph, go to the box on that page with the corresponding icon
for pertinent information.
Ô
— Note
63-5048