Radio Shack 63-955 User Manual
© 1999 Tandy Corporation.
All Rights Reserved.
RadioShack is a registered trademark used by Tandy Corporation.
Your RadioShack Traveling Recording
Picture Frame/Alarm Clock combines a
clock with a recorder that uses the latest
IC (memory) recording technology to
record sounds without tape or moving
parts. You can easily see the time, and
you can record an important message as
well. At a time you set, you can have the
recorder play the message automatically.
The IC lets you record a new message as
many times as you like.
The clock includes these features.
Large Display — lets you easily see the
time and alarm settings.
Built-In Photo Frame — holds a favorite
picture.
10-Second Solid-State Recorder —
records and plays a single message as an
alarm or memo.
Clock Alarm — alerts you with a repeat-
ing series of four beeps, or announces the
prerecorded message.
Compact Size — makes it handy to pack
or carry wherever you go.
PREPARATION
Removing the Battery
Insulation Strips
Your picture frame/alarm clock comes
equipped with four type 357A button-cell
batteries already installed. However, be-
fore you can use the clock, you must re-
move the plastic insulation sheet from
inside the battery compartment.
Cat. No. 63-955
Traveling Recording Picture Frame/Alarm Clock
1. Use a Phillips
screwdriver to
remove the
screw from the
battery compart-
ment cover.
2. Slide off the bat-
tery compart-
ment cover.
3. Grasp the white plastic sheet and
gently pull it off.
4. Make sure the batteries are in posi-
tion, then replace the battery cover
and secure it with the screw.
Framing a Picture
Select a picture or photograph which is
thin enough to fit into the frame’s slot. Trim
the picture to 2
5
/
8
×
2
3
/
8
inches (66
×
60
mm), then insert the picture from the top of
the frame and push it down until it touches
the bottom of the frame.
To replace the picture, slide it up until it
clears the upper edge frame opening.
Photo
63-955.fm Page 1 Monday, August 9, 1999 5:39 PM