Radio Shack ET-1755 Owner's Manual

Manual is about: 3-Line Phone With Speakerphone

Summary of ET-1755

  • Page 1

    © 2002 radioshack corporation. All rights reserved. Radioshack and radioshack.Com are trademarks used by radioshack corporation. 43-1755 owner’s manual — please read before using this equipment. Thank you for purchasing our radioshack 3-line phone that lets you place or receive calls from three sepa...

  • Page 2

    2 auto-line selection — automatically selects a line so you do not need to press a line button. Auto-ringer selection — automatically selects the line which is ringing, or line 1 when three lines are ringing simultaneously. Hearing aid compatible — lets you use this telephone with hearing aids that ...

  • Page 3

    3 (%%"56#6'/'06 your telephone complies with part 68 of fcc rules. You must, upon request, provide the fcc registration number and the ren to your telephone company. Both numbers are on the bottom of the telephone. ± .+)*60+0) your telephone has built-in protection circuits to reduce the risk of dam...

  • Page 4

    4 1 0 " # "& '5- 1. Insert the mounting bracket’s four tabs into the slots on the bottom of the base then slide up to snap the mounting bracket into place. 2. If you have a two-line phone jack and a one-line phone jack, plug one end of the supplied two-line long modular cord into line l1/ l2 on the ...

  • Page 5

    5 if the wall plate has a single one-line phone jack, and there is a two-line phone jack nearby, plug one end of the supplied one-line short modular cord into l3 , and plug the two-line long modular cord into line l1/l2 . Then plug the one-line short modular cord’s other end into the wall plate jack...

  • Page 6

    6 %100'%6+0)"61"#016*'4" 2*10'" the phone is equipped with a data jack so you can connect another phone or an answering machine to line2. You can plug one end of a modular cord into either line l1/l2 or l3 , or data at the right side of the phone, then plug the other end into the jack of another pho...

  • Page 7

    7 5'66+0)"6*'"&+#.+0)"/1&' set tone/pulse on the bottom of the phone for the type of service you have. If you are not sure which type you have, do this simple test. 1. Set tone/pulse on the bottom of base to tone . 2. Lift the handset, or press speaker/headset to listen for a dial tone. 3. Press any...

  • Page 8

    8 5 9+6%*+0) "$ '69''0 " 6*' "* #0&5'6 " #0& " 6*' "5 2'#-'42*10' to switch from the handset to the speakerphone at any time during a call, press speaker/headset so the speaker indicator lights. ± to switch from the speakerphone to the handset, just lift the handset. The speaker indicator turns off....

  • Page 9

    9 75+0)"*1.& to put a call on hold, press hold . The line indicator flashes. You can then hang up the handset or use the other phone line (or answer another call, for example) without disconnecting the current call. To resume the call, press that line’s button ( line 1, line 2 or line 3 ) if the han...

  • Page 10

    10 for an upper memory location, press a memory number button. For a lower memory location, press lower , then a memory number button. After completion, the lower indicator flashes. To store additional numbers, repeat steps 1–3. ' 06'4+0) " # "2 #75' " +0 " # "/ '/14; "0 7/$'4 in some telephone syst...

  • Page 11

    11 2. Write the name or number next to the appropriate memory location on the provided card. The card has an upper and lower position for each memory location. 3. Insert the plastic cover’s tabs into the slots on the base, align the memory buttons with the cover and carefully press down on the cover...

  • Page 12

    43-1755 02a02 printed in malaysia radioshack corporation fort worth, texas 76102 if you still have problems, disconnect the phone. If other phones on the same line(s) work properly, the fault is in this phone or its installation. If you cannot find the problem, take your phone to your local radiosha...