Radio Shack Pocket Weatheradio 12-257 Owner's Manual

Manual is about: with Tone and Vibrating Alert

Summary of Pocket Weatheradio 12-257

  • Page 1

    © 2001 radioshack corporation. All rights reserved. Radioshack and radioshack.Com are trademarks used by radioshack corporation. Owner’s manual — please read before using this equipment. Pocket weatheradio with tone and vibrating alert your radioshack pocket weatheradio is designed to receive nation...

  • Page 2

    2 fcc declaration of conformity this device complies with part 15 of the fcc rules . Op- eration is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired ...

  • Page 3

    3 however, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television recep- tion, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference...

  • Page 4

    4 installing batteries your radio uses three aaa batteries for power. For the best performance and the longest life, we recommend radioshack alkaline batteries. Note: do not use a rechargeable battery in your weath- eradio. 1. Press down on the battery compartment cover and slide it off. 2. Install ...

  • Page 5

    5 power indicator when the weatheradio is on and the batteries have full power, the power indicator flashes green. When the weatheradio is on and the batteries are low, the power indicator flashes red. When the weatheradio is on but no radio signal is detected, the power indicator flashes orange. Te...

  • Page 6

    6 radio sounds a tone, and the power indicator lights green. 3. To turn off the tone or vibration alert, turn the radio off. Listening to the radio 1. Set alert/weather to weather . 2. Hold the weatheradio so the antenna is vertical. 3. Rotate volume/off counter- clockwise until it clicks and wait s...

  • Page 7

    7 • if alert/weather is set to weather when the current channel becomes unavailable, the radio does not switch channels. • if alert/weather is set to weather and no channels are available, a short tone sounds every 30 second and the power indicator flashes orange. • after you turn on the radio, if t...

  • Page 8

    8 vere weather threatens, do not wait for an alert tone; turn on your weatheradio and monitor the latest weath- er information. 1. Set alert/weather to alert and tone/vibra- tor to tone or vibrator . 2. Rotate volume/off counterclockwise until it clicks and wait several seconds for the weatheradio t...

  • Page 9

    9 the tone starts, you hear the broadcast tone for the remainder of the 10 seconds, then the emer- gency information. • the radio sounds the alert tone at full power, regardless of the volume setting. 3. When the weatheradio sounds an alert tone or vibrates, slide alert/weather to weather to hear th...

  • Page 10

    10 important: clear reception of a weather broadcast sig- nal does not guarantee that an emergency alert broad- cast will trigger your weatheradio’s alert function. Be sure you choose the proper location for the weatheradio and regularly check the weatheradio to be sure it is op- erating properly. C...

  • Page 11

    11 specifications frequency coverage channel 1 ........................................................... 162.400 mhz channel 2 ........................................................... 162.425 mhz channel 3 ........................................................... 162.450 mhz channel 4 ..........

  • Page 12

    12-257 ao0056aaa1 03a01 printed in china radioshack corporation fort worth, texas 76102 limited ninety-day warranty this product is warranted by radioshack against manufacturing defects in material and work- manship under normal use for ninety (90) days from the date of purchase from radioshack comp...