Radio Shack UHF/VHF TV ANTENNA User Manual

©

 1999 Tandy Corporation.

All Rights Reserved.

RadioShack is a registered trademark used by Tandy Corporation.

Cat. No.

15-1864

UHF/VHF TV ANTENNA

Your UHF/VHF TV Antenna is com-

pact, easy-to-install and provides su-

perb reception for UHF and VHF TV

stations.

Your Antenna includes these features:

Four-Section Telescoping Chrome

Arms — swivel up to180° for the best

VHF and FM reception.

High-Gain UHF Loop — lets you re-

ceive UHF stations in most metropoli-

tan areas.

Weighted Felt Base — will not mar or

scratch a TV cabinet.

Connecting and Operating

the Antenna

1. Place the antenna on top of the

TV set or near the FM receiver.

2. If your receiver has a 75-ohm FM

connector, screw the antenna's

cable F-connector onto the TV's

antenna terminals or your FM re-

ceiver's antenna terminals. Then

turn the connector clockwise to

tighten and secure the connection.

Note: If your receiver has a 300-

ohm twin-lead connector, you

need an optional adapter (avail-

able at your local RadioShack

store). Screw the adapter onto the

antenna cable. Then tighten and

secure the adapter's lead to the TV's

antenna terminals or receiver's FM

terminals.

3. Individually adjust the length and

position of the antenna rods to get

the best reception.

Note: Some rooms have dead

spots, or null points, where no TV

signals can be received. If the re-

ception is poor, move the antenna

for maximum performance.

For the best VHF/FM reception, extend

the antenna rods as follows:

• Channels 7–13: 

1

/

4 

to

fully extended

• FM Stations: 

3

/

4

 to fully extended

For the best UHF reception, rotate the

antenna base.

15-1864.fm  Page 1  Thursday, July 29, 1999  2:38 PM