Radio Shack Zeraxa 6001352 User Manual - page 3
4
5
Charge the Drone Battery
Your drone uses a lithium polymer battery for power.
1. Use a screwdriver to open the drone battery compartment door.
2. Take out the battery. Holding the battery connector (NOT the
cable), carefully unplug the battery from the drone.
3. Use the USB charging cable to connect the battery to a USB
power source, such as a laptop. The LED on the USB connector
lights red during charging, and turns off when charging is
complete.
A full charge takes about 100 minutes. A fully charged battery
provides up to 5 minutes fly time with camera function.
4. After charging, unplug the USB charging cable. Do not attempt
to overcharge the battery.
Caution: Use and charge only the supplied lithium battery with the
included USB charging cable. Using any other battery and cable may
damage the drone.
LED
Battery Notes
• Always let the drone battery cool before recharging.
• Dispose of old batteries promptly and properly. Do not burn
or bury them. Use only fresh batteries of the required size and
recommended type.
• Do not mix old and new batteries, different types of batteries
(standard, alkaline, or rechargeable), or rechargeable batteries of
different capacities.
• If you do not plan to use the drone for a long period, remove the
batteries from the remote control. Batteries can leak chemicals
that can damage electronic parts.
Lithium Battery Notes
• Do not puncture or crush. Do not disassemble.
• Do not dispose of lithium batteries in the trash.
• If the electrolyte in the cells should get on your skin, thoroughly wash
with soap and water. If in the eyes, rinse thoroughly with cool water.
Immediately seek medical attention.
• Follow the manufacturer’s instructions for charging the drone and
do not charge longer than recommended. Unplug the charging
cable when the drone is charged.
• Do not attempt to charge or operate damaged toys.
6001352_UG_EN_030315.indd 4-5
3/3/2015 2:52:38 PM