Outdoor antenna kit instruction manual.
Outdoor antenna kit the outdoor antenna kit moves the antenna outside the obstructions caused by the walls of the location, and typically, increases the distance of the signal, allowing you to reach distances of up to a quarter-mile. The outdoor antenna kit contains: auxiliary transmitting unit (atu...
Whip antenna connector the atu. The following is an illustration of the atu and it’s parts. Placement. The outdoor antenna should be mounted directly to the outside of a building in an inconspicuous location within sight of where you want your messages to be heard. It typically allows you to signifi...
Step action 1 you’ll need to purchase a five-foot length of one inch diameter metal pipe in a five foot length and drive this into the ground where you want the antenna installed. 2 open the pole mount hardware kit (supplied). 3 place the 4 screws through the screw holes in the mounting brackets on ...
Permanent mounting of the outdoor antenna. Use the steps below to permanently mount the outdoor antenna to a building. This would be used any time you need some extra distance to reach listeners at a location where the transmitter is likely to remain for an extended period of time. Step 2 step 4 ste...
Outdoor antenna connect antenna select two-part message select part 1 part 2 custom power input 120 vac remove key to prevent changes to message or frequency basic outdoor isd4004-8 speaker volume must be off when using a microphone to avoid feedback 18 vdc back-up microphone: speak into vent on cab...
Tuning the outdoor antenna. Follow the steps below to tune the outdoor antenna. Step action 1 make sure that the transmitter is operating inside the location and is set to your chosen frequency. 2 open the cover of the atu. 3 select hi or low on the hi/low frequency switch. If you are broadcasting o...
