RadioLink Ei168 User Manual - 1. Quick Installation Guide
1. QUICK INSTALLATION GUIDE
For use only with Ei Electronics Easi Fit Mains Powered
Smoke Alarms Ei141, 144, 146, 161, 161R, 164, 166 & 166R.
The Ei168 RadioLINK Base must be installed by a qualified
electrician.
1.1) Install each RadioLINK Base in the centre of the ceiling
at least 0.30m from light fittings (as per the smoke/heat
alarm instructions) and connect to nearest mains circuit
(see page 3).
1.2) Slide alarm on to the Ei168 RadioLINK Base. This will auto-
matically activate the rechargeable back-up cells. Repeat
this procedure for all alarms in the system (see page 5).
1.3) To House Code, insert a small screwdriver into the house
code switch slots of each unit in succession. This must be
completed within 15 minutes to activate the house code
mode and ensure zoned interconnection (see page 6). It
is essential that the RadioLINK Bases are house
coded.
1.4) Button test each alarm to ensure that
they are all communicating.
1
This guide is for quick referencing only. You must read
the user manual thoroughly before installation and use.