Radiolink t8fb (fhss) instruction manual 8ch remote control system radiolink eletronic limited technical updates and additional programming examples available at: www. Radiolink.Com.
1 introduction thank you for purchasing radiolink 2.4 ghz 8 channels remote control system -- t8fb . It can operate helicopter, fixed-wing, glider, aircraft models. Communication system adopts fhss. Parameter setting designed applicable to both beginners and skilled person. In order to better use re...
2 note:about flying while you are getting ready to fly, if you place your transmitter on the ground ,be sure that the wind won’t tip it over. If it is knocked over, the throttle stick may be accidentally moved, causing the engine to speed up. Also, damage to your transmitter may occur. Other than 2....
3 contents part 1. Introduction of t8fb system ...................................................... 4 1.1 transmitter panel shows..................................................................................... 4 1.2 t8fb remote control system......................................................
4 part 1 introduction of t8fb system 1.1 transmitter panel shows:.
5 1.2 t8fb remote control system 1.2.1 transmitter 1) one two-way switch, one three-way switch, two vr switches, four trimmers, two sticks. 2) defaulted mode2, swb control ch5, vrb control ch6, swa control ch7, vra control ch8. 3) defaulted low battery alarm voltage is 11.1v, can setting in the t8fb...
6 once the link is made, the id code is stored in the receiver and no further linking is necessary unless the receiver is to be used with another transmitter. When you purchase another r8eh, this procedure is necessary; otherwise the receiver will not work. 1) place the transmitter and the receiver ...
7 to extend the length. Avoid plugging multiple extensions together to obtain your desired length. If the distance is greater than 50cm or high current draw servos are being used, use heavy servo extensions. • receiver vibration and waterproofing: the receiver contains precision electronic part.Be s...
8 of the switch in both directions. •when install the switch harness to the helicopter, please use the switch cover. Generally sandwich the frame between the switch and switch cover and securely tighten the screws. Different models might require different installations. If so, please follow the mode...
9 part 2 parameter configuration 2.1 preparation 1. Install the t8fb upgrade drive files first. 2. Connection: one end of t8fb usb cable connect to computer and the other end connect to the upgrade port which at the back of t8fb. T8fb upgrade connector connection: txd connect to white wire. Rxd conn...
10 3. Open t8fb parameter configuration software.(p2) （ p2 ） 4. Choose port number(t8fb connection com will automatic identified when connect to computer), setting baud rate: 115200 , 8-1-none (8 data bits,1 stop bit,no parity check),click “connect”.(p3) （ p3 ）.
11 2.2 software description “read”: computer will read data from transmitter and show on the computer when click “read”(red and green led will quick flashing when reading). “load”: load configured txt files. “update”: write down the new data you want and then click “update” to change the defaulted p...
12 ailevator, etc. This is so that each individual servo can be carefully fine-turn to avoid binding and other conflicts. To adjust the total travel of a function such as flaperon, make the adjustments in that function's controls. The higher the end point setting, the better position accuracy and th...
