Radionics D6680 Installation Manual

D6680

Network Adapter

Installation Guide

1.0

Introduction

The Radionics D6680 Network Adapter is a two-channel network adapter. The D6680 includes a cable for

connecting to DB25 Channel 1 Port. For most NetCom installations, only one channel needs to be used and

configured.

These instructions should be followed to avoid the possibility of physical damage to the operator,

program and/or equipment.

1.1

Network Interface

Figure 1: Network Interface

Note:

Do not attempt to connect both Ethernet ports

simultaneously. The D6680 does not have

routing capabilities.

The D6680 has the following items on the

Network Interface end of the unit.

1.  10BASE-T Ethernet Port (refer to Figure 2)

2.  10BASE-FL Ethernet Port (Transmit)

– Not Used

3.  10BASE-FL Ethernet Port (Receive)

– Not Used

4. Network 

LEDs

5. Power 

Plug

1.1.1

RJ-45 10BASE-T Ethernet Port

Figure 2: RJ-45 Ethernet Jack Pinouts

1.2

Serial Interface

Figure 3: Serial Interface

The D6680 has the following items on the

Serial Interface end of the unit.

1.  DB9 Serial Port (DTE) – Not Used

2. Serial 

LEDs

3.  DB25 Serial Port (DCE)

1.2.1

DB25 Serial Port (DCE)

Figure 4: 25-pin Serial Port