RadiSys Endura QZ35Q Quick Start Manual - page 2
Installation Guide
2
Quick Start
To install and operate your motherboard, do the following:
Install the motherboard into a suitable chassis.
Attach all necessary components and peripheral devices to the appropriate headers and
connectors on the board.
Power on the system.
Run the BIOS setup utility if you need to change any settings. To start the BIOS setup utility, press
the Delete key when prompted during system startup.
Attaching components and devices
See
Figure 2, “Motherboard layout: top view”
on page 3 for the location of components and
connectors on the motherboard. Refer to the Endura Q35 Motherboard Product Manual for further
information on interfaces and supported devices.
Attaching devices to the rear I/O panel
The I/O ports are color-coded in conformance with the PC 99 specification, and are designed to accept
standard cables. If necessary, refer to the product manual for the pin definitions of each connector.
Figure 1. Rear I/O panel
Video devices
The motherboard can be used with the following video devices:
1. VGA monitor, connected to the rear I/O panel VGA port
2. PCI Express x16 graphics cards
1
3. Media expansion cards
1
A second PCI Express x16 card can be used in the PCI Express x4 slot, but will have a reduced bandwidth.
PS/2
VGA
COM1 Serial
Mouse
Line Out
Line In
Keyboard
Microphone
In
USB
LAN 1
USB
LAN 2
Audio