Radstar rs300 operating instructions rs300 features indicator light power jack printer port • 12 or 24-hour start time delay option • internal memory to retain data print button clear button key switch ino28 - rev d • accurate measurement in a wide range of temperatures and relative humidity • nomin...
1.0 setting up the rs300 2.0 turning unit on 3.0 erasing stored data 4.0 monitoring for radon gas 5.0 obtaining a reading from the rs300 6.0 setting up the optional printer 7.0 obtaining a test report printout 8.0 downloading data from the radstar 9.0 transporting the radstar to a pc or printer figu...
2 .0 turning unit on : 2.1 insert key into unit and turn it one click to the right to the [ keypad on ] position. The unit will beep. 3.0 erasing stored data: 3.1 press and hold the [ hold to clear ] button. There will be an audible tone coming from the unit when this is done. Release the [ hold to ...
4 5.0 obtaining a reading from the rs300: 5.1 any time during or after a test turn the keyswitch to [keypad on] position. Note: to continue testing at anytime when the keyswitch has been turned to the [ keypad on ] or the [ off ] position, simply turn the keyswitch to [ measure on ] position. Note t...
5 9.0 transporting the radstar to a pc or printer : 9.1 if desired, you may transport the radstar to a pc or printer to retrieve the data. Turn keyswitch to [ off ] position remove key and disconnect power supply. When your destination is reached, simply insert key into unit and turn to [ keypad on ...
Figure a example rs300 test result printout 6.
Manufactured by radonaway 3 saber way ward hill, ma 01835.
Mode: continuous monitor, passive diffusion principle of operation: pulse mode ionization chamber minimum sensitivity: 0.27 cpm/pci/l (minimum 64 alpha counts per hour @ 4 pci/l) units: picocuries per liter (pci/l) dynamic range: 0.5 to 150 pci/l linearity: +/- 10% best straight line data storage (n...