RADSON ELATO ET Installation Manual - Turbo
3
TURBO
Blower option 1000 watts
ENG
FILTER CLEANING
The blower Turbo is equipped with an anti-dust filter which when saturated, can
cause the blower to stop (see “Thermal safety”).
The filter’s indicator light 1 lights up in solid red at the end of 200 hours use. In this
case the blower function becomes inoperable. The filter should then be cleaned.
The blower indicator light remains solid green whatever the orders emitted by the
timer of the FM radio infrared emitter.
Important:
The appliance must remain switched on to allow deletion of the filter
cleaning alarm :
You will find these pictograms for your filter’s cleaning procedure on the filter itself of your blower.
3. Clean your filter using a vacuum
cleaner or rinsing it under water.
4. Reposition the filter in the same way
as in figure 2 by sliding it to the right
or left.
5. Press the button for 3 seconds.
This operation deletes the alarm. The
filter alarm is triggered again at the
end of 200 hours use.
1. Filter cleaning alarm: FILTER indicator
light solid red.
2. Remove the filter by sliding it to the
right or left of your appliance.