Rae AutoRAE 2 User Manual - Autorae 2 Cradle
AUTORAE 2 CRADLE
3. Overview
An AutoRAE 2 Cradle can be deployed as a stand-alone station for automatic charging,
bump testing, and calibrating monitors and printing certificates on a serial printer, or as
part of an AutoRAE 2 Controller-based system, which can accommodate up to 10
AutoRAE 2 Cradles. These can be all the same or a mix of MultiRAE, MicroRAE,
QRAE 3, and ToxiRAE Pro models, as well as MiniRAE Lite, MiniRAE 3000, ppbRAE
3000, and UltraRAE 3000.
When an AutoRAE 2 Cradle is connected to the AutoRAE 2 Controller, all electrical,
electronic, and gas connections are automatically internally connected. A controller-
based system can accommodate up to five distinct gas sources for multi-sensor
calibration and bump testing.
An AutoRAE 2 Cradle can be used on a tabletop (or other flat surface) or mounted on a
wall. Wall-mounting instructions are included in this guide.
MultiRAE Cradle
Exhaust port
(not shown)
2 gas inlets
(not shown)
End cap,
right
DC input
from AC
adapter
Air inlet
Filter
Sensors for
testing
MultiRAE
LED alarms
Sensors for
testing
MultiRAE
LED alarms
Sensor for
testing
MultiRAE
buzzer
Release
mechanism
Capture
mechanism
USB port
(not shown)
2-character
LED display
Bump/Status
LED
Bump
key
Charge contacts
Charging status
LED
Cal
key
Cal/Status
LED
End cap, left