Rage stinger 240 Instruction Manual - page 3
3
Charging the Flight Battery
Connect the USB charging adapter to a USB port on
your computer or a USB power adapter. The red LED will
illuminate.
Connect the lead from the battery to the lead from the
charging adapter.
When the red LED light is on, the battery is fully charged.
Transmitter Battery Installation
Remove the screw from the battery cover using the
supplied screwdriver. Press down on the arrow and slide
the battery cover toward the bottom of the transmitter
to remove.
Insert the four AA batteries. Align the + and - on the
batteries and transmitter when installing the batteries.
Return the battery cover into position. Reinstall the screw
to secure the cover.
Landing Gear Installation
Install the main landing gear by aligning the pegs on the
gear with the holes in the bottom of the drone. The gear
will angle out away from the drone when installed. The
front and rear landing gear are different and will only fit
the proper holes in the bottom of the drone.
Blade Guard Installation
Install the blade guards by aligning the pegs on the
guards with the holes in the motor pods. Press the guards
completely down so they are resting on the pods. Failure
to do so may cause interference with the blades.
Camera Installation
Use the supplied screwdriver to attach the camera mount
to the battery door.
The camera is then slid into position in the slots on the
mount. Guide the camera control wire between the
camera and mount as shown to prevent tangling or
damage should your model land in tall grass.