Summary of SR2611-2S-S2+
Page 1
V2.1 (july, 2009) sr2611-2s-s2 user manual.
Page 2: Index
Index check package contents and accessories......................................................... 3 hardware introduction......................................................................................... 4 system requirement & environment requirement and notices......................... 4...
Page 3
Check package contents and accessories sr2611 system includes the following: item quantity sr2611 1 removable carrier 2 internal rs232 cable 1 external rs232 cable 1 45cm sata cable 1 product cd 1 accessory bag 1 (includes 6#-32 screws x 8 pcs , key for keylock x 2) sr2611 removable carrier internal...
Page 4: Hardware Introduction
Hardware introduction front panel real panel 1 lcd panel 2 hdd tray 1 esata port 2 power socket 3 mute button 4 key lock 3 rs232 port 4 5cm fan 5 hdd access led 6 fail led note : status indications of leds: hdd access led will flash yellow when the data is accessed from the hard drive. Fail led will...
Page 5
Following email:supporting@raidon.Com.Tw and we will reply as soon as possible. 5. The sr2611 is equipped with a 5.2 cm ball bearing cooling fan that will provide effective cooling for the 7200&10000 rpm hard drive. We highly recommend using computer chassis with effective cooling design to avoid di...
Page 6
Connecting sr2611 to your computer 1. Connect dc12v&5v power cables and sata cables to sr2611. 2. Secure rs232 set on the sr2611 machine 3. Connect sr2611 to the motherboard com 1 with rs232 cables which included in the ac cessory pack as shown in the picture. 45cm sata cable power supply connector ...
Page 7: Drive With Existing Data
Setting the hard drive array mode installing two brand new hard drives 1. Place two new hard drives into sr2611 at the same time. 2. Use the disk manager in the operating system to partition and format the hard drive after turning the machine on. At this point, sr2611 will be treated as a single har...
Page 8: Computer Set Up
Computer set up when the hardware setup for sr2611 is complete, you are now ready to turn the machine on. 1. After the hardware installation is complete, the sr2611 will be treated as one single hard drive. Set the hard drive to auto in the computer’s bios. When the computer is turned on, the system...
Page 9: Hot Swap & Auto Rebuilding
Experiences any abnormality during the operation, please refer to the trouble shooting q&a section in appendix. Hard disk status on lcd screen left hard drive (primary hard drive) fail right hard drive (secondary hard drive) normal primary hard drive storage capacity larger than secondary hard drive...
Page 10
The lcd display message during hot swap and auto rebuilding when the sr2611 detects a hard drive missing or a hard drive failure, the buzzer will go off and the lcd display screen will display the following messages: 1. After removing the failed hard drive and replacing with a new hard drive, if the...
Page 11: Hard Drive Failure
4. When cooling fan module is not functional, “f” will be displayed on the lower right-hand corner of screen. (as shown in illustration) appendix: trouble shooting / q&a unstable system after connecting sr2611 q: after installing sr2611, we are unable to start the computer or the computer can not lo...
Page 12: Other Possible Situations
Installing the hard drives into sr2611. Once the original hard drive is designated and installed in sr2611, the user can place in the second hard drive by taking advantage of sr2611’s auto rebuilding function. Q: my hard drive is obviously operating properly but why is it shown as failed in the sr26...
Page 13
Note: raidon technology, inc. Only provides technical support and service to those who buy prod ucts directly from us. For end users or those who do not buy products directly from us, please contact your distributor for prompt and better responses. If your product is not purchased directly from raid...