Raidon SR7650-4S-U3D Quick Manual - 2. Quick Install
2. Quick Install
You can easily create a volume by using the “Quick install” function. On RAID levels 0, 1, 3,
5 and 6, the system will automatically calculate the maximum available capacity, which is
subject to the number of your hard disks and currently available capacity.
2.1 Select “Quick install” and then select a RAID level. Please refer to the following figure.
After selecting a RAID level, click “
” to enter next page to configure
“Bus ID” / “SCSI ID”/“LUN”.
2.2 Select an ID for each device and avoid ID conflict in the same SCSI bus. You can change
the volume size in this page. The maximum volume size will be displayed. Please enter a
value less than or equal to that value and then click “
”.
2.3 Confirmation page. Click “
” if all the settings are correct. User data
volume created will be displayed.
3. Connect SCSI Cable to SCSI-A or SCSI-B port on the back
panel of SR5650-4S-U3D / GR5800-8S-U3D (users need to
install SCSI adapter on the computer in advance) and proceed
the following process.
4. Initialize Disk
4.1 To format the hard disk, please right-click the “My Computer” icon and then select
“Manage”.