Rail King Amtrak F59PH Operation manual - page 15
You can obtain replacement bulbs directly from the M.T.H. Parts Department
(Order online: www.mth-railking.com, e-mail: parts@mth-railking.com,Fax: 410-
423-0009, Phone: 410-381-2500, Mail: 7020 Columbia Gateway Drive, Columbia
Locomotive Light Bulb Replacement
To replace the burned out light bulbs on this locomotive, follow these instructions.
Follow the cab removal instructions in the “Lubrication and Greasing
Instructions” section on pg.12 of this manual. Once the body has been removed,
locate burned out light bulb(s). Carefully remove bulb(s) from mounting.
Disconnect light bulb harness from main harness wire.
Replacement bulb harnesses are available directly from the M.T.H. Parts
department.
Connect replacement bulb harness and reassemble in reverse.
15
RailKing
Diesel R-T-R Freight/Passenger Set w/Proto-Sound® 2.0
F59PH
C
aboose Light Bulb Replacement
To replace the interior light bulbs follow these instructions and see the diagrams below.
Remove the four (4)
screws located under
the caboose's trucks.
Lower the chassis from the
shell, taking care not to pull
the wires out.
STEP
1
1
STEP
2
2
Carefully loosen the
end frames on both
ends from the step
platform.
Then grasp the end
frame by the bottom
and pivot outward 5
degrees. Remove
the step platforms
from both ends.
Lower the chassis from the shell, taking
care not to pull the wires out.
Step
Platform
End
Frame
STEP
3
3
STEP
4
4
STEP
5
5
Replace the bulb by pushing the socket up
at an angle from the bulb holder and pulling
the bulb from its socket.
Replace with a new bulb and reverse the
steps to reassemble the caboose.
Light Bulb
(Part #CG-0000017)