Rail King F-3 Passenger Set Operation Manual

Other manuals for F-3 Passenger Set: Operating Instructions Manual

Summary of F-3 Passenger Set

  • Page 1

    Thank you for purchasing this railking product. Please read before use and save operation manual f-3 passenger set ® (3v ps2) www.Railking.Com.

  • Page 2: Table of Contents

    Table of contents set up set up checklist . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 assembling realtrax® . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 connecting the transformer . . . . . . . . . . . . . . . . . . . . . . . . . . 5 lubricating the engine...

  • Page 3: Set Up Checklist

    Set up checklist • assemble realtrax® • connect the transformer • lubricate the engine • place the engine and cars on the track and couple them together • apply power to run as described in the basic operation section of these instructions. Tools needed cotton swab or rag scissors pliers philips scr...

  • Page 4: Assembling Realtrax™

    Assembling realtrax™ unlike other o gauge track systems, each realtrax section features a realistic built-in roadbed base, solid nickel-silver track rails, and realistic railroad ties, all designed to give you an authentic looking track system. The quick connectors and built-in roadbed allow you to ...

  • Page 5: Connecting The Transformer

    Connecting the transformer lubricating the engine you must lubricate the engine before operating it. Use a light household oil and follow the lubrication points marked “l” in fig. 3 on page 11. Do not over oil. Use only a drop or two on each pivot point. Coupling the engine and cars our couplers are...

  • Page 6: Basic Operation

    Basic operation volume control – to adjust the volume of all sounds made by this engine, turn the master volume control knob located under the engine clockwise to increase the volume and counter-clockwise to decrease the volume (see fig. 2). The throttle knob controls how fast your train will travel...

  • Page 7

    Proto-sound 2.0 operating instructions this manual contains the operating instructions for proto-sound 2.0 in conventional mode only. Instructions for accessing dcs command mode features accompany the dcs remote control system equipment (sold seperately). Activating proto-sound 2.0 conventional mode...

  • Page 8: Tips On Using Psa

    Tips on using psa • you can terminate psa at anytime by turning off power to the track for 15 seconds. • you do not have to be in forward to use psa. At the conclusion of the full sequence, the train will pull away from the station in whatever direction you were going when you activated the feature....

  • Page 9: Proto-Coupler® Operation

    Proto-coupler® operation this locomotive is equipped with two coil-wound proto-couplers for remote uncoupling action. Because the proto-coupler is controlled through the proto- sound 2.0 microprocessor, it does not require an uncoupling track section or modification to your layout to function. Use t...

  • Page 10

    Lock into a directional state: you can lock your engine into a directional state (forward, neutral, or reverse) to prevent it from changing directions. To do this, put the engine into the direction you want or into neutral, to lock it into neutral, run it at a very slow speed ( scale mph), and quick...

  • Page 11: Maintenance:

    Maintenance: lubrication and greasing instructions the engine should be oiled and greased in order to run properly. You should regularly oil the engine and pickup rollers to prevent them from squeaking. Use light household oil and follow the lubrication points marked “l” in fig. 3. Do not over oil. ...

  • Page 12

    5. Repeat the procedure for the other motor and truck 6. Reassemble the chassis and body, being careful that the wires are not caught between the body and chassis, as this can lead to a short that may damage the electronics beyond repair. It is also a good idea to lubricate the outside truck block i...

  • Page 13

    Traction tire replacement instructions your locomotive is equipped with two neoprene rubber traction tires on the rear set of flanged drivers. While these tires are extremely durable, you may need to replace them at some point. 1. Remove the truck sides from the truck block in order to slip the new ...

  • Page 14

    Locomotive light bulb replacement to replace the light bulb in the locomotive, follow these instructions: follow the cab removal instructions found in the “lubrication and greasing” section of this booklet. Once the body has been removed, rotate the headlight bulb counter-clockwise as seen in figure...

  • Page 15

    Figure 7: passenger car light bulb replacement railking f-3 r-t-r passenger set with proto-sound® 2.0 15.

  • Page 16

    Self-charging battery back-up the special nicad 2.4v self-charging battery pack recharges continuously during train operation and should last for up to five years. The battery is a dry battery that should not leak or cause any damage to your engine. Depending upon when your engine was built, it may ...

  • Page 17

    Quick-start dvd the included dvd quick-start video demonstrates the start-up and basic operation of this set as well as other information about model railroading. You may find it helpful to view the dvd before operating this set. Railware interactive cd rom m.T.H. Provides a free railware cd rom in ...

  • Page 18

    Troubleshooting proto-sound® 2.0 problems although proto-sound 2.0 has been designed and engineered for ease of use, you may have some questions during initial operation. The following table should answer most questions. If your problem cannot be resolved with this table, contact m.T.H. For assistan...

  • Page 19

    Railking f-3 r-t-r passenger set with proto-sound® 2.0 19 volume remedy the sounds seem distorted, especially when the horn or bell is activated. No sound proto-sound 2.0 volume is set too high. Turn the volume control knob on the bottom of the chassis counter-clockwise to reduce the volume. Volume ...

  • Page 20: Compatibility

    Transformer compatibility and wiring chart note that many of the operational commands described in these instructions require a bell button, so if you are using a transformer other than the one included in this set and your transformer does not have its own bell button, you should consider adding on...

  • Page 21: Dcs Remote Control System:

    Additional features accessible with the dcs remote control system: (additional equipment required) while conventional mode operation of a proto-sound 2.0 engine yields wonderfully realistic sound and several train control features, command mode operation allows the user to access a world of command ...

  • Page 22

    $price name and number part # per unit 1.) diaphragm ( black )( 3 rib ) fi-0000017 2.00 ( 26.0x50.0x10.0mm )( 2 center mount tabs ) 2.) shell ( ny yankees #1903 ) fc-2200376 *85.00 shell ( new haven #488 ) fc-2200377 *85.00 shell ( caterpillar # 2004 ) fc-2200378 *85.00 shell ( b&o #67) fc-2200379 *...

  • Page 23

    F-3 diesel locomotive engine parts $price name and number part # per unit 27.) bracket ( black )( metal ) ih-0000386 3.00 ( 8.0x62.5mm )( 18.5mm step )( 2 mounting holes ) ( mounts speaker cone ) 28.) volume pot ( small ) bi-0000040 5.00 ( blue pot mounted on green pc board ) 29.) spacer ( black ) i...

  • Page 24

    F-3 diesel locomotive engine parts $ p r i c e name and number part # per unit 54.) truck side ( black ) db-2150002 7.00 truck side ( silver ) db-2150006 7.00 (fits 2 axle truck)(truck side screws mount from bottom) 55.) screw ia-0000058 0.15 ( m2x4.0mm )( roundhead ) 56.) wire harness bc-0000190 10...

  • Page 25

    47 46 45 44 43 47 46 45 51 52 43 49 59 18 51 44 52 49 18 59 48 58 54 56 54 54 54 42 40 39 29 29 26 28 23 31 30 27 41 60 19 24 34 37 22 17 22 17 35 36 61 15 16 14 13 12 23 8 61 9 11 10 9 7 2 1 4 42 32 38 38 5 61 61 57 55 61 33 21 21 3 6 18 18 50 20 59 53 18 18 3 25 25 f-3 a unit diesel engine engine ...

  • Page 26: Limited One-Year Warranty

    Service & warranty information how to get service under the terms of the limited one-year warranty when you suspect an item is defective, please check the operator's manual for standard operation and trouble-shooting techniques that may correct the problem. Additional information may be found on the...

  • Page 27: Participating A.S.C.

    Alabama colorado illinois southerland station custom railway supply berwyn's toy trains & huntsville colorado springs models 256-533-4720 719-634-4616 berwyn 708-484-4384 caboose hobbies, inc. Arizona denver chicagoland hobby arizona train depot 303-777-6766 chicago mesa 773-775-4848 480-833-9486 mi...

  • Page 28

    Holly beach train depot louisiana minnesota wildwood america's train yard don's hobby co. 609-522-2379 baton rouge mankato 225-926-5592 507-387-1330 new york l b c model trains maine missouri s buffalo wheels, wings & things switch stand 716-631-3081 ludlow saint louis 207-532-6277 314-781-4458 kurt...

  • Page 29

    The freight yard charleroi sweeper rhode island smithfield center grandma's house 919-934-6229 charleroi grandpa's train 724-483-3397 warwick little choo choo shop 401-463-7803 inc. Jerry quinn trains & toys spencer coatesville south carolina 704-637-8717 610-383-1931 emerald train & hobby greenwood...

  • Page 30: Participating N.A.S.C. List

    English model rr california michigan montoursville tin plate junction michigan model trains 800-327-5126 oakland pinckney 510-444-4780 734-426-1651 toby tyler’s hobby cen. Pittsburgh brasseur elec. Trains colorado 412-653-5030 saginaw mizell trains 989-793-4753 westminster virginia 303-429-4811 locu...