Rail King M10000 Operating Instructions Manual - Basic Operation
Basic Operation
Throttle
– Throttle up the power to your track. Give enough power so that
the engine’s headlight shines brightly. Then put the engine into motion by
either firmly pressing the Direction button on your transformer or remote once
or dropping and advancing the throttle to put the engine in forward.
Operation Buttons
Use the operation buttons on your transformer as described below.
Horn/Whistle - To sound the horn, firmly press the Horn/Whistle button. The
whistle will sound for as long as you continue to depress the button. It will
stop when you release the button. The whistle has four different endings,
depending on whether you hold the button for less than three seconds, three
seconds, four seconds, or five seconds or longer.
Bell - To sound the bell, firmly press and release the Bell button. To turn the
bell off, press and release the Bell button again. The bell will continue to ring
from the time your turn it on until you press and release the button again to
turn it off.
Direction – Your train is programmed to start in neutral. To put the engine
into forward and then to change the direction of the train or to put it into
neutral, firmly press and release the Direction button on your transformer.
Just as you must stop your car between forward and reverse, this engine will
not go directly from forward to reverse; it goes into neutral between
directions. If the train has been moving forward, the first press of the
Direction button will put the train from forward into neutral, the second press
into reverse, the third press back into neutral, and the fourth back into
forward. To prevent accidental high-speed start-ups, this engine is
programmed to restart in neutral each time the track voltage is turned off for
10 seconds or more.
4
RailKing M10000 Diesel Engine