Rail King PCC Street Car Operating Instructions Manual - Factory Defaults
18
RailKing PCC Street Car Operating Manual
The lockout feature comes from the factory in the OFF position, meaning it
is not active when you first take the engine out of the box. This is done to
prevent novice operators from accidentally locking their engine into
forward, neutral or reverse and then mistakenly thinking that the engine’s
electronics have failed. To activate the Remote Lockout Control setting, go
to RESET Feature 40 (See the section entitled Using RESET To Program
ProtoSounds® on page 13). Once in Feature 40, press the transformer
whistle button and wait for ProtoSounds® to sound a bell ding. Continue
pressing the whistle button
until ProtoSounds® sounds
two bell dings signifying
that the Remote Lockout
Control has been selected.
To lock in the setting,
simply turn the throttle all
the way off and then back
on again. To turn the
Remote Lockout Control setting back off, go back to Feature 40 and press
the whistle button until only one bell ding sounds. To lock in the setting,
simply turn the transformer throttle off and then back on again.
Alternatively, you can go to RESET Feature 18 to reset all ProtoSound®
features back to their original factory defaults including Remote Lockout
Control.
RESETTING ALL PROTOSOUND® OPTIONS TO
FACTORY DEFAULTS
ProtoSounds® is equipped with a RESET feature (Feature 18) that resets
all programmable options back to their original factory settings. This is a
useful feature if you find your engine not operating the way you think it
should and don’t want to take the time to check each RESET feature one at
a time. To reset all the RESET features back to their original factory
settings, enter RESET and go to Feature 18. (See the section entitled Using
RESET To Program
ProtoSounds® on page 13).
Once in Feature 18, press the
transformer whistle button
and wait for ProtoSounds® to
sound a garbled bell sound.
Interrupt the throttle again to
lock in the setting.
In RESET Mode
Move The Throttle
Up & Down From
High Voltage To Low
40 Times
Listen For 8 Clank
And 0 Clink Sounds
Push The Whistle Button
Until You Hear
2 Bell Dings
Interrupt The Throttle
To “Lock-In”
The Lockout Setting
H
In RESET Mode
Move The Throttle
Up & Down From
High Voltage To Low
18 Times
Listen For 3 Clank
And 3 Clink Sounds
Push The Whistle Button
Until You Hear
A Warbled Bell Ding
Interrupt The Throttle
To “Lock-In”
The Default Settings
H