Rail King RAILKING GALLOPING GOOSE Operating Instructions Manual - Operation
16
RailKing Galloping Goose™ Operating Manual
PROGRAMMING FOR SQUEAKING BRAKE
OPERATION
ProtoSounds® can be programmed for squeaking brake operation in three
different manners; (1)Squeaking brakes can be activated by bell button
control, (2)they can be
programmed for
continuous operation
subject to throttle changes
or (3)they can be
programmed to be turned
off. The default setting is
(2) Squeaking brakes are
activated for full-time
operation as described on
page 6. To change the default setting, enter RESET and go to Feature 45.
(See the section Using RESET To Program ProtoSounds® on page 13).
Once in Feature 45, press the whistle button and wait for the module to
sound a bell ding(s). Continue pressing the whistle button until the module
plays back one ding for option 1 - Squeaking brakes are activated by the
bell button with SAS operation. Press the whistle button again until the
module plays back two dings for option 2 - squeaking brakes are activated
for full-time operation, or press the whistle button again until the module
plays back three dings for option 3 -Squeaking brakes off. Once you have
decided on the desired setting, simply turn the throttle off and then on again
to “Lock-In” the new setting. To reset the computer to its original factory
default setting (option 2 - squeaking brakes are activated for full-time
operation), repeat the above procedure but keep pushing the whistle button
until the module only responds with two bell dings.
PROGRAMMING FOR HORN IN NEUTRAL
OPERATION
If you are operating your
Galloping Goose™ with a
separate bell button and want
to blow your horn when your
Galloping Goose™ is in
neutral, you will need to
program ProtoSounds® to do
so as the factory setting only
allows the horn to blow in forward or reverse. To do this, enter RESET and
go to Feature 25. (See the section Using RESET To Program
ProtoSounds® on page 13.) Once in Feature 25, press the transformer
In RESET Mode
Move The Throttle
Up & Down From
High Voltage To Low
45 Times
Listen For 9 Clank
And 0 Clink Sounds
Push The Whistle Button
Until You Hear The
Appropriate # Of Dings
Interrupt The Throttle
To “Lock-In”
The Brake Setting
H
In RESET Mode
Move The Throttle
Up & Down From
High Voltage To Low
25 Times
Listen For 5 Clank
And 0 Clink Sounds
Push The Whistle Button
Until You Hear
2 Bell Dings
Interrupt The Throttle
To “Lock-In”
The Horn Setting
H