Rainbow e2-73db User Manual - Replacing The Power Nozzle
18
replacing the power nozzle
™
belt
!
WARNING:
Always disconnect from
electrical supply when servicing.
1. Turn the Power Nozzle upside down. Using
a fl at-bladed screwdriver or coin, turn
the fastener a quarter-turn to the left
(counterclockwise).
2. Using both thumbs, push tabs on both sides
of sole plate outward while lifting to unlock.
3. Next, insert index fi ngers into two side
openings near wheels. Pull side tabs up
while pushing in to lift off sole plate.
4. Rotate brush roll assembly forward (note
that rollers are upside down) and remove.
5. a) Slide worn or broken belt off motor
shaft with fi nger; b) Lift brush roll out and
remove worn belt.
6. Place new belt over the end of brush roll
assembly. Position new belt around the
pulley.
7. a) Place brush roll upside down with rollers
centered on top of two side tabs. Slide belt
over end of motor shaft; b) Rotate brush roll
assembly forward until rollers are face up.
Spin brush roll toward you to position the
belt on the center of the pulley.
8. Position sole plate over top of Power Nozzle
cover. Press down until front, two side tabs
and back tabs snap and lock in.
9. Using a fl at-bladed screwdriver or coin,
turn the fastener a quarter-turn to the right
(clockwise) to lock sole plate. Assembly is
complete.
For best performance, we recommend you replace your Rainbow Power Nozzle belt every 12 to 18 months, or when
you notice decreased cleaning performance. Your Power Nozzle comes with one replacement belt, and can be easily
changed in just a few minutes. This replacement belt is located in the spare belt pocket under the sole plate. For
additional replacement belts, contact an Authorized Rainbow Distributor.
1
2
3
4
6
7
8
9
5a
5b
9
1