Important safety instructions read and follow all the instructions caution: do not plug the power supply into a grounded outlet or do not switch the pool cleaner “on” if it is not fully immersed in water. Operating the cleaner out of water will cause severe damage immediately and will result in loss...
12 cm (4.7 inch) 3.6m/11.8ft 1 1a 1. Place the power supply (transformer) at least 3.6 meters / 11.8 feet from the pool and at least 12 cm / 4 inch above the surface (fig.1). The transformer will supply low voltage to the cleaner. 2. Uncoil the cable.(fig.1a) unit operating the pool cleaner - quick ...
Operating the pool cleaner - plugging the cable 4 a b slot key c d plugs type i to plug the cable (fig a) into the socket on the power supply (fig. B), please do the following: 1.Prepare the plug as seen in (fig. C) with the key and 3 outside slots exactly as shown. 2.Fit exactly the key and the slo...
5 maintenance and adjustment - cleaning the filter operating the pool cleaner - power button a. Power led the blue led flashes when the power supply is in standby mode and lights continuously when the pool cleaner is operating.The power button switches between on and standby b. "power" button the bu...
Maintenance and adjustment - changing the rolling brush maintenance and adjustment - accessing and cleaning the propeller 6 1 10 5 6 4 1 2 click new brush 3 pump motor 4 3 2 7 8 9.
8 please check the following before calling your service center before troubleshooting, the pool cleaner must be disconnected from the power supply and the power supply must be unplugged from the electrical outlet to prevent damage to the unit and possible personal injury. 1. Unit does not pump wate...
