Onga tankbuddy submersible pump code description kw v otb450a tankbuddy-onga sump pump 0.65 230
Technical information pump discharge connection: 1 1/4” bspf thread supplied fitting: 1 1/4” hose tail power supply: 230v - 1ph - 50hz voltage limits: 207v - 253v (230v ± 10%) maximum flow rate: 100 lpm maximum head: 32m water temperature range: 1°c – 40°c power consumption: 800w fla (full load amps...
Installation tankbuddy is electrically connected. Ensure that it is switched off and unplugged from the electrical supply during installation and any subsequent service work. These instructions are a guide only. Should you the installer or owner of the product be unfamiliar with the correct installa...
Pump installation securely connect a stainless steel wire cable or a rope to the handle of the pump ensuring that the wire/cable exceeds the safe working load of 10kg. If you are using a hard discharge pipe, thread this into the outlet of the pump housing. If you are using a flexible discharge hose,...
Operation check 1. Connect the pump to a suitable power outlet. 2. Ensure that the pump is completely submerged. If it is not, fill the tank with water from another source, until the pump is completely submerged. 3. The float switch will rise, and the pump will start, and empty the tank. As the tank e...
Symptom cause remedy pump doesn’t start float switch isn’t in the ‘on’ position wait until there is more water in the tank to start the pump not enough water in the tank to get the float above level float is caught on something, and can’t rise above level ensure that the float can move freely no power...
Symptom cause remedy pump runs intermittently: thermal protection inside the pump is tripping and resetting the pump is not completely submerged ensure pump is covered with water water temperature is too high ensure that water temperature limits are observed. Pump runs intermittently when the pump s...
