Rainforest Automation EAGLE Quick Start Manual - Easy Steps:
GET DIRECT ACCESS TO YOUR REAL-TIME
ENERGY INFORMATION IN THREE
EASY STEPS:
STEP 1: REGISTER WITH YOUR UTILITY
You will need to provide your MAC Address and Install Code from
the Information Label on the bottom of your EAGLE
™. It may take
some time for your utility to enable your meter to connect to your
device. It is important to wait until this is complete before
proceeding to the next step.
STEP 2: PLUG IN YOUR EAGLE™
Connect the Ethernet cable to your router, and plug in the power
adapter. Use only the included adapter to power your EAGLE
™.
If another adapter is used, it may cause permanent damage to
your
EAGLE™.
It should take about two minutes for your EAGLE
™ to boot up.
STEP 3: CONNECT TO THE CLOUD
Create your Cloud Account and connect to your EAGLE
™ to start
viewing your energy data.
rainforestcloud.com
Click on the word “Register” in the lower right corner.
Fill in the registration information and click the blue “Register” bar.
Check your email to find the message from Rainforest Automation
with the subject line “Please confirm Your Registration”. Click the
link in the email.
Enter your email address and password. Click the blue “Submit” bar.
Click the blue “+ New Gateway” bar.
Enter the Cloud ID and the Install Code for your EAGLE
™ (these
numbers can be found on the Information Label that is on the
underside of your device). Click the blue “Add” bar.
Click the connect icon ( ).
SEE THE FULL EAGLE™ USER GUIDE ON OUR WEBSITE:
rainforestautomation.com/eagle_support
CONNECTING TO THE CLOUD
Use your Web Browser to go to rainforestcloud.com