Rainforest Automation RFA-Z109 EAGLE Quick Start Manual - Eagle
EAGLE
™(beta)
Quick Start
Rainforest EAGLE™ Information Label
Setup
Step 1: Prerequisite software and hardware
1) Access to an Ethernet connection directly connected to the Internet.
2) A PC or other device with a web browser and an internet connection (for access to cloud
service).
Step 2: Provision the EAGLE
™
EAGLE
™ needs to be provisioned just like an In-Home Display.
You will need the Install Code and MAC Address, which are found on the Information Label on
the underside of the EAGLE
™.
Note that it may take some time for the smart meter to receive this information. You must wait
until this process is complete before proceeding.
Step 3: Power up the EAGLE
™
1) Connect the EAGLE
™ Ethernet port to a switch/router that is connected directly to the
Internet.
2) Attach the EAGLE
™ AC power cord, and plug it into a wall outlet. Allow 2 minutes for the
device to boot up.
Step 4: Setup the EAGLE
™ upload server
Ensure that your PC is connected to the same network as the EAGLE
™. Start up your web
browser and enter the EAGLE
™ Network Address (found on the Information Label on the
Install
Code
MAC
Address
EAGLE
™
Network
Address
Cloud
ID