Rainforest EMU-2 User Manual - Emu-2
www.rainforestautomation.com
EMU-2
™
User Manual
19
will be flashing. To change this digit, press the Top Button and cycle through the
numbers 0-9 until the desired value is displayed. Then press the Bottom Button to save
this digit. The next digit to the left will then be flashing. Repeat the process until all five
digits show the desired values. After the last digit is saved, your EMU-2
™ will go to the
Billing Dates screen.
Billing Dates
The Billing Dates screen shows you the
start and stop dates for the current billing
period. This screen can only be accessed
in Configuration Mode, after going through
the Restart, Select Language, and Set
Rate screens. The billing dates shown are
used as the current accumulation period
that is displayed on the Total to Date
screen. At the end of the billing period,
the accumulated data is transferred to the
Previous Totals screen, and the next billing period is automatically started.
The default billing period is a simple monthly cycle, beginning at 00:00:01 on the first
day of the month, and ending at midnight on the last day of the month. To change this
setting, press the Top Button to get to the Set Billing Date screen. Otherwise, press the
Bottom Button to go to the Battery screen.
Set Billing Date
The Set Billing Date screen allows you to
set the billing period that will be used as
the current accumulation period displayed
on the Total to Date screen.
The Last Billing Date is shown on the
lower left of the screen. If it has not been
set before, it will be the word “monthly”,
and will be flashing. Press the Top Button
to select
“manual”. This will allow you to
set the accumulation period manually in
the Total to Date
screen. If you choose “monthly”, then the billing period is set to the
default simple monthly cycle described above.
Billing Dates
start:
Jan 01 Set
stop:
Skip
Jan 31
Set Billing Date
Enter Last
Billing Date: Change
monthly Keep