- DL manuals
- Ralink
- Network Card
- MS-6890
- User Manual
Ralink MS-6890 User Manual
Summary of MS-6890
Page 1
I wireless 11b/g/n 1t2r mini card quick user’s guide pdf created with pdffactory pro trial version www.Pdffactory.Com.
Page 2
Ii h iermit erklären wir dass sich dieses produkt in Übereinstimmung mit den grundlegenden anforderungen und den anderen relevanten vorschriften der richtlinie 1999/5/eg befindet. Hereby, we declare that this device is in compliance with the essential requirements and other relevant provisions of di...
Page 3
Iii prescribed use: this product integrates a wlan- and/or bluetooth ® device. The device sets up a radio link between to computer. In addition it is possible to link the wlan- or bluetooth ® device to any other wlan- or bluetooth ® device which stick to the ieee 802.11b/g or bluetooth ® requirement...
Page 4: Fcc Caution
Iv fcc caution 1. The device complies with part 15 of the fcc rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. 2. Fcc ...
Page 5: C Or
V important safety precautions always read and follow these basic safety precautions carefully when handling any piece of electronic component. 1. Keep this quick installation guide for future reference. 2. Keep this equipment away from humidity. 3. Lay this equipment on a reliable flat surface befo...
Page 6: Copyright Notice
Vi copyright notice the material in this document is the intellectual property of the manufacturer. We take every care in the preparation of this document, but no guarantee is given as to the correct- ness of its contents. Our products are under continual improvement and we reserve the right to make...
Page 7: Table Of Content
Vii table of content ce compliance ...........................................................................................................Ii fcc caution ...............................................................................................................Iv fcc statement ..................
Page 8: Introduction
1 introduction the wireless 11b/g/n 1t2r mini card, which can be used to integrate with such systems as notebook, mini-barebone and por- table pc. With wireless 11b/g/n 1t2r mini card embedded inside, a system could provide users with the ability and flexibility to con- nect up to internet wirelessl...
Page 9: >>>
2 ad-hoc mode : an ad-hoc network is a local area network or other small network, especially one with wireless or temporary plug-in connections, in which some of the network devices are part of the network only for the duration of a communications session. Users in the network can share files, print...
Page 10
3 infrastructure mode : the difference between infrastructure network and ad-hoc network is that the former one includes an access point. In an infrastructure network, the access point can manage the bandwidth to maximize bandwidth utilization. Addi- tionally, the access point enables users on a wir...
Page 11: >>> 1.3 Specifications
4 >>> 1.3 specifications network standard ieee 802.11n draft 2.0 ieee 802.11b/g frequency band 2.400-2.4835ghz form factor mini card v1.1 antenna connector two antenna connectors data rate ieee 802.11g (auto-fallback): - ofdm: 54, 48, 36, 24, 18, 12, 9 and 6 mbps ieee 802.11b (auto-fallback): - cck:...
Page 12: Ieee 802.11G (Ofdm)
5 ieee 802.11g (ofdm) bpsk@6, 9mbps qpsk@12, 18mbps 16-qam@24, 36 mbps 64-qam@48, 54mbps ieee 802.11n draft 2.0 (ofdm) ofdm@6.5 to 150mbps (follow mcs 0~7 standard) network architecture ad-hoc mode (peer to peer) infrastructure mode temperature 0 o c to 80 o c operating storage -20 o c to 100 o c hu...
Page 13: Output Power
6 output power 802.11g 54mbps, 14.0+1/-1 dbm 802.11b 11mbps, 17.5+/-1 dbm 802.11n draft2.0 14.0+/-1dbm receiver sensitivity 54 mbps ofdm@ 10% per = -65dbm 11 mbps cck@ 8% per = -70dbm 802.11n draft 2.0 ht20@10% per= -64dbm ht40@10% per= -61dbm range up to 300m (outdoor operating range) security 64/1...
Page 14
7 >>> 1.4 system requirements before installing wireless 11b/g/n 1t2r mini card, your pc should meet the following items: - one notebook pc with an available mini slot. - windows ® 2000/xp /vista 32/64-bit operating system. - minimum 5mb free disk space for installing the driver and utilities. - one...
Page 15: >>> 1.6 Product View
8 >>> 1.6 product view golden finger wlan 11b/g/n 1t2r antenna connectors connect to external antennas for enhanced data transmission and reception. The external antennas are well designed on the desktop or note- book computers. Pdf created with pdffactory pro trial version www.Pdffactory.Com.
Page 16: Hardware Installation
9 hardware installation 1. Locate the mini slot on the mainboard.Place your wireless 11b/g/n 1t2r mini card over the mini card slot (at an angle of 30 degree). Then, gently insert it into the slot until the golden finger of the card gets fully inserted. 2. Press down the card, and the retaining clip...
Page 17: Software Installation
10 software installation this chapter describes the procedures of installing the driver and utility. Follow the instruction step by step to finish the installation. If you use windows ® 98se/me, please prepare the windows ® setup cd at hand before installing the driver; because the sys- tem will ask...
Page 18: E:\setup.Exe
11 click the welcome screen of installshield wizard appears. Read and accept the license agreement; then click next. Step 2 after installing the wireless 11b/g/n 1t2r mini card to your computer and then turning on the computer, the operating system will detect a new device and start the configuraton...
Page 19
12 the program will copy the necessary files to the system. The progress indicator shall show the installing status. Click finish when the installation is completed. The wireless lan icon will appear in the notification area. Wireless lan icon step 3 step 4 pdf created with pdffactory pro trial vers...
Page 20: Network Connection Window.
13 since the wireless 11b/g/n 1t2r mini card has been installed in your computer, you have to configure the settings for communi- cation to start working in your network environment. >>> 4.1 infrastructure mode click the wireless lan icon to bring up the wireless network connection window. Infrastru...
Page 21
14 step 2 step 3 in the tab of site survey, select the network you want, and then click add to profile. You also can click rescan to search the available access point in the network again. If the access point selected to connect has been connected and had set up the authentication/encryption, you ne...
Page 22
15 step 4 then select the access point from the profile list and click activate to complete the configuration. Click step 5 from the relevant connectivity information such as status and link guality to see if you’ve finished the configuration successfully. Check status and link quality to confirm su...
Page 23
16 step 6 please click help icon for more detail configuration information. Click for more info pdf created with pdffactory pro trial version www.Pdffactory.Com.