Service guide ser 339610-1 339610-1 alemite, llc 167 roweland drive, johnson city, tennessee 37601 www.Alemite.Com copyright © 2005 by alemite, llc this document contains confidential information that is the property of alemite, llc 670854 and is not to be copied, used, or disclosed to others withou...
Ser 339610-1 low-pressure transfer pump revision (8-06) 2 figure 2 low-pressure transfer pump model 339610-1 - exploded view 1-800-548-1191 - http://www.Partdeal.Com - info@partdeal.Com.
Low-pressure transfer pump ser 339610-1 3 revision (8-06) repair kits part no. Kit symbol description 393763 kit, major repair (includes tube of 393590 teflon grease) 393708 kit, repair, air motor keeper 393530-24 kit, seal [includes five (5) of item number 14] 393530-26 kit, seal [includes five (5)...
Ser 339610-1 low-pressure transfer pump revision (8-06) 4 accessories performance curves a pump’s ability to deliver material is based on the pressure (psi/bars) and quantity (cfm/lpm) of air supplied to the motor and the amount of material discharge [back] pressure to be overcome within the system....
Low-pressure transfer pump ser 3396101-1 5 revision (8-06) overhaul note: refer to figure 2 for component identification on all overhaul procedures. Prior to performing any maintenance procedure, the following safety precautions must be observed. Personal injury may occur. Warning do not use halogen...
Ser 339610-1 low-pressure transfer pump revision (8-06) 6 pump body assembly 1. Install and seat seal (14) [stem end first], bearing (15) [stepped end first], seal (16) [stem end first], and washer (17) into the bottom of pump body (10). 2. Secure the components with retaining ring (18). • make sure...
Low-pressure transfer pump ser 3396101-1 7 revision (8-06) air piston caution use care not to switch washers (4 and 8). Com- ponent damage can occur. 9. Install washer (8) [brass color] , o-ring (7), and air piston (5) (observe this side up] onto the rod. 10. Install washer (4) [silver color] and nu...
Ser 339610-1 low-pressure transfer pump revision (8-06) 8 21. Install the cylinder over the body’s o-ring and seat it properly onto the bottom cap. 22. Install the top cap onto the cylinder. • use care passing the o-ring. 23. Install keeper (11) into the groove of the body. • make sure the hole alig...
Low-pressure transfer pump ser 3396101-1 9 revision (8-06) troubleshooting chart pump indications possible problems solution pump does not cycle 1. Air motor not operating properly 2. Pump tube jammed and/or contains loose components 3. Insufficient air pressure 1. Inspect air motor and rebuild or r...
Ser 339610-1 low-pressure transfer pump revision (8-06) 10 1-800-548-1191 - http://www.Partdeal.Com - info@partdeal.Com.