Rampage ACD-83 Owner's Manual - page 11
10
10
10
10
10
OPEROPEROPEROPEROPER
AAAAA
TTTTT
ING INSTRUCING INSTRUCING INSTRUCING INSTRUCING INSTRUC
TTTTT
IONSIONSIONSIONSIONS
Disc play is stopped and the disc is ejected
when the front panel is folded down and this
button on the rear of the panel is pressed.
Radio or CD changer operation will automatically
resume depending on which mode was in
operation prior to disc play. If the disc is
not removed from the unit within 15 seconds
of being ejected, it will automatically be re-
loaded into the unit to prevent it from being
accidentally damaged ( will appear on the
display panel to indicate that a disc is
loaded in the player). Play of the disc can
be resumed by using the MODE button
bt
to choose CD player function.
ct
TIME/FREQUENCY SELECTOR (T/F)
During radio operation, press this button to
call the time display on the incorporated
quartz clock. The current time will appear
together with an AM or PM indication. The
display will return to the radio frequency
indication after 5 seconds.
During CD player operation, a second press
of this button will call the time display.
During CD changer operation the first press
of the button will call the time display. In
either case, the display will return to the
disc indication after 5 seconds.
cu
EQUALIZER BUTTON (EQ)
The EQ button applies preset sound effects
to the unit’s audio output signal. The EQ
button, when pressed, will activate one of
three operating modes (ROCK, CLAS, or
POP). When the EQ function is active, as
displayed on the panel, the bass and treble
levels cannot be changed. When the EQ
function is not active, the unit returns to the
user set bass and treble levels.
dl
THEFT-DETERRENT LED
Located on the chassis behind the front
panel, a light-emitting diode (LED) will flash
when the panel is physically removed. The
flashing light serves as a visual warning to
the would-be thief that the unit has been
disabled by removal of the front panel.
dm
RESET BUTTON
The RESET button is located to the right of
the theft deterrent LED. The reset circuitry
should only be activated under the following
circumstances as it will erase the time
and pre-set memories:
1.Upon initial installation after all wiring is
completed.
2.If there is a malfunction of any of the
switches on the unit, pressing the RESET
button may clear the system and return
to normal operation.
dn
FRONT PANEL RELEASE BUTTON
(OPEN)
This button is used to release the
mechanism that holds the front panel to the
chassis. To detach the front panel, press
the button so that the panel drops to the
lowered position. Grasp the panel at the
middle and pull it off of the chassis. To re-
attach the panel, press it straight onto the
chassis until the mechanism locks it into
place.
NOTES ON USE OF FRONT PANEL:
1. Make sure the front panel is positioned
correctly when attaching it to the chassis
as it cannot be attached when up-side
down. Use modeate pressure to fully seat
the panel into position.
2.To verify correct panel installation, swing the
panel assembly up into position until it locks
easily into place. If any resistance is
encountered, re-check panel opientation in
chassis mounting plate.
3. When taking the front panel with you,