RAMSET RT400 M Operator's Safety & Operating Instruction Manual - Magazine Assembly
The Ramset RT400 magazine features a
unique slip-clutch mechanism allowing the
user to position the magazine at any angle.
To Adjust The Magazine Angle:
Rotate the magazine to the desired position.
To Remove/Install the Magazine:
1. Be sure the tool is unloaded and
remove any remaining fasteners
from the magazine.
2. Unscrew the barrel retention sleeve,
remove the pawls, slide out the barrel
assembly and remove the spring.
These steps are further detailed on
page 15.
3. Rotate the barrel and magazine so
the square holes in the side of the
magazine line up with the slots in
the magazine collar.
4. Place the pawls into the square holes
in the magazine. With the fastening end
of the barrel pointed away from you,
turn the barrel counter-clockwise to
remove it from the magazine assembly.
5. The magazine can be installed by
following the reverse of the steps
shown above.
MAGAZINE ASSEMBLY
MAGAZINE ASSEMBLY
17
TO ADJUST POSITION —
ROTATE IN EITHER DIRECTION
SLIDE BARREL ASSEMBLY
OUT OF THE TOOL BODY
RT400 WITH MAGAZINE ATTACHED
GRASP ASSEMBLY AROUND PAWLS
TO SCREW ON MAGAZINE