1. DL manuals
  2. RAMSET
  3. Tools
  4. TRAKFAST
  5. Repair Manual

RAMSET TRAKFAST Repair Manual

Other manuals for TRAKFAST: Repair Manual

Summary of TRAKFAST

  • Page 1

    Trakfast repair manual rev. 09/07 tool operation overview magazine assembly the magazine assembly has two functions. Its primary func- tion is to store and feed fasteners into the nose of the tool. Its secondary function is to house the battery and battery contact assembly. Motor assembly the motor ...

  • Page 2: Trakfast Repair Manual

    Trakfast repair manual rev. 09/07 tool operation start and pre-combustion when lower probe (e) is pressed against the work surface, cage (f) is forced against the spring (g). Combustion chamber (h) is raised up against cylinder head (i), and o-rings (j & m) seal off the combustion chamber, creating ...

  • Page 3: Trakfast Repair Manual

    Trakfast repair manual rev. 09/07 combustion depressing the trigger activates the ignition circuit. This causes a spark (n) to jump the gap between the spark element and cylinder head, igniting the fuel/air mixture in the combustion chamber. Pis- ton assembly (o) is forced downward driving the faste...

  • Page 4: Trakfast Repair Manual

    Trakfast repair manual rev. 09/07 tool operation power/exhaust downward movement of the piston assembly, past exhaust ports (p), allows exhaust gases to exit. The pressure of the exhaust gases against the flat washer compresses the wave washers, allowing the gases to flow through the mid-check area ...

  • Page 5: Trakfast Repair Manual

    Trakfast repair manual 0 rev. 09/07 tool operation return reduced pressure within the combustion chamber allows wave washers (t) to reseal the combustion chamber. Rapid cooling of gases trapped in the combustion chamber (u) creates vacuum. This vacuum is strong enough to lift and hold the pis- ton a...

  • Page 6: Trakfast Repair Manual

    Trakfast repair manual rev. 09/07 tool operation purging the combustion chamber drops when the tool is lifted from the work surface and the trigger is re- leased. This opens the seal between the combustion chamber and cylinder head o-ring (w) and sleeve o-ring (x). The fan is now able to circulate f...