Rand McNally OverDryve Pro User Manual - IV.  Fcc Statement

Restricted Rights Legend. For governmental agencies: Use, reproduction or disclosure is 

subject to restrictions set forth in subparagraph (c) (1) (iii) of the Right in Technical Data 

and Computer Software clause at DFARS 52.227-7013, as amended. 

Rand McNally, TripMaker, the Rand McNally logo and the globe design mark are registered 

trademarks and OverDryve is a trademark of RM Acquisition, LLC, d/b/a Rand McNally.  

Portions ©  2016 HERE. All rights reserved. This data includes information taken with 

permission from Canadian authorities, including ©  Her Majesty the Queen in Right of 

Canada, © Queen’s Printer for Ontario. 

©  2016 InfoGation. All rights reserved. 

©  2016 Rand McNally. All rights reserved. U.S. Patent Nos. 7,580,791 and 8,214,141. 

IV.  FCC STATEMENT 

This device complies with Part 15 of the FCC Rules. Operation is subject to the following 

two conditions: 

(1) this device may not cause harmful interference, and 

(2) this device must accept any interference received, including interference that may 

cause undesired operation. 

FCC Statement 

This equipment has been tested and found to comply with the limits for a Class B digital 

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide 

reasonable protection against harmful interference in a residential installation. This 

equipment generates uses and can radiate radio frequency energy and, if not installed and 

used in accordance with the instructions, may cause harmful interference to radio 

communications. However, there is no guarantee that interference will not occur in a 

particular installation. If this equipment does cause harmful interference to radio or 

television reception, which can be determined by turning the equipment off and on, the 

user is encouraged to try to correct the interference by one or more of the following 

measures: 

—Reorient or relocate the receiving antenna. 

—Increase the separation between the equipment and receiver. 

—Connect the equipment into an outlet on a circuit different from that to which the 

receiver is connected. 

—Consult the dealer or an experienced radio/TV technician for help. 

Caution! 

Any changes or modifications not expressly approved by the party responsible for 

compliance could void the user's authority to operate the equipment.