Randell CR9039 Operator's Manual - Trouble Shooting Guide

Other manuals for CR9039: Specifications

Manual is about: CR9000 Series Countertop Rails

Page of 16

Download

Print this page

Bookmark us

800-621-8560

Trouble Shooting Guide

SYMPTOM

POSSIBLE CAUSE

PROCEDURE

Unit doesn't run

1. No power to unit

1. Plug in unit (check power switch)

2. Temperature control turned off

2. Check temperature control

3. Temperature control faulty

3. Test temperature control

4. Compressor overheated

4. Clean condenser coil

5. Condenser fan faulty

5. Service condenser fan

6. Overload protector faulty

6. Test overload

7. Compressor relay faulty

7. Test relay

8. Compressor faulty

8. Call ASA for service

Unit short cycles

1. Condenser coil dirty

1. Clean coil

2. Condenser fan faulty

2. Service fan and motor.

3. Compressor faulty

3. Call ASA for service

4. Overload repeatedly tripping

4. Check outlet voltage

Unit runs constantly

1. Condenser coil dirty

1. Clean coil

2. Condenser fan faulty

2. Service condenser motor

3. Covers off unit

3. Re-apply covers

Unit too cold

1. Temperature control set too

low

1. Adjust control to raise setting

2. Temperature control faulty

2. Test control

Unit noisy

1. Compressor mountings loose

or hardened.

1. Tighten or replace compressor

mountings

2. Condenser fan damaged or

hitting fan shroud

2. Inspect condenser fan

« ‹ Prev 10 11 12 13 14 15 16 Next › »

Summary of CR9039

Page 1
2/27/2008 pp mnl0018 operator’s manual this manual provides information on installation, operating, maintenance, trouble shooting & replacement parts for cr9000 series countertop rails notify carier of damage at once. It is the responsibility of the consignee to inspect the container upon receipt of...
Page 2: Table Of Contents
2 2 2 2 800-621-8560 table of contents page 2………………………………….…………congratulations page 3……………………………………parts & service hotline page 3………………………………...…serial number location page 4-7……………………………….Randell limited warranty page 8…………………………………………unit specifications page 9…..………………………………………...Unit installation...
Page 3: 800-621-8560
Unifiedbrands.Net 3 in addition, all randell food service equipment is backed by some of the best warranties in the food service industry and by our professional staff of service technicians. Retain this manual for future reference. Notice: due to a continuous program of product improvement, randell...
Page 4: Warranty Policies
4 4 4 4 800-621-8560 warranty policies randell believes strongly in the products it builds and backs them with the best warranty in the industry. Standard with every unit comes the peace of mind that this unit has been thoroughly engineered, properly tested and manufactured to excruciating tolerance...
Page 5
Unifiedbrands.Net 5 temperature adjustments are not covered under warranty, due to the wide range of ambient conditions. For warranty inquiries call our field service department at: 1-800-621-8560. When optional 5 year compressor warranty applies 1. Provide reimbursement to an asa for the cost of lo...
Page 6
6 6 6 6 800-621-8560 notice: food loss is not covered under warranty 3. Repairs caused by abuse such as broken glass, freight damage, excessive force, or scratches and dents. 4. Electrical component failure due to water damage from cleaning procedures. Quotations verbal quotations are provided for c...
Page 7
Unifiedbrands.Net 7 damages all crating conforms to general motor carrier specifications. To avoid concealed damage, we recommend inspection of every carton upon receipt. In the event the item shows rough handling or visible damage to minimize liability, a full inspection is necessary upon arrival. ...
Page 8: Unit Specifications
8 8 8 8 800-621-8560 unit specifications cr9060 shown with optional hood cover model l d h* pan capacity hp volt amps nema shit wt. Cr9039 39” 18” 23.5” (3) 1/3 or (6) 1/6 ¼ 115/60/1 7.1 5-15p 133 cr9046 46” 18” 23.5” (4) 1/3 or (8) 1/6 ¼ 115/60/1 7.1 5-15p 162 cr9053 53” 18” 23.5” (5) 1/3 or (10) 1...
Page 9: Unit Installation
Unifiedbrands.Net 9 unit installation selecting a location for your new unit the following conditions should be considered when selecting a location for your unit: 1. Countertop load: the area on which the unit will rest must be level, free of vibration, and suitably strong enough to support the com...
Page 10: Unit Operation
10 10 10 10 800-621-8560 unit operation randell has preset the cold control to ensure that your unit runs at an optimum temperature, but due to varying ambient conditions, including elevation, food product as well as type of operation, you may need to alter this temperature. Additional adjustments c...
Page 11: Preventive Maintenance
Unifiedbrands.Net 11 preventive maintenance randell strongly suggests a preventive maintenance program which would include the following monthly procedures: if a failure of the equipment is a direct result of any of the preventative maintenance guidelines being neglected the repairs will not be cove...
Page 12
12 12 12 12 800-621-8560 preventive maintenance (cont.) proper maintenance of equipment is the ultimate necessity in preventing costly repairs. By evaluating each unit on a regular schedule, you can often catch and repair minor problems before they completely disable the unit and become burdensome o...
Page 13: Electrical Diagram
Unifiedbrands.Net 13 electrical diagram.
Page 14: Trouble Shooting Guide
14 14 14 14 800-621-8560 trouble shooting guide symptom possible cause procedure unit doesn't run 1. No power to unit 1. Plug in unit (check power switch) 2. Temperature control turned off 2. Check temperature control 3. Temperature control faulty 3. Test temperature control 4. Compressor overheated...
Page 15: Replacement
Unifiedbrands.Net 15 replacement parts cr9000 series.
Page 16: Replacement
16 16 16 16 800-621-8560 replacement parts cr9000 series cr 9000 series item description part # 9 0 3 9 9 0 4 6 9 0 5 3 9 0 6 0 9 0 6 7 9 0 7 4 9 0 8 0 9 0 8 7 9 0 9 9 2 adapter bar - 13.25" x 7/8" rp bar1325 x x x x x x x x x 3 hinged cover 23" rp pcr0802 x 3a hinged cover 30" rp pcr0803 x 3b hinge...